User manual KRESS WS 1100

[. . . ] Intermediate shims may not be used on conical or offset grinding wheels. When mounting recessed abrasive wheels, the diameter of the spring flange must be at least 5 mm smaller than the diameter of the flat recess surface of the abrasive wheel and must not press on the transitional curve of the recess. The location holes of grinding wheels must not be bored afterwards because of the danger of breakage this involves. The grinding wheels must sit on the spindle in such a way that they are easily moveable without being too loose. [. . . ] The dust produced when working with crystalline silicic acid is harmful to health. Do not use the grinder on any material containing asbestos. Also applicable to this tool are the separately enclosed safety notes, which we recommend following. Outside power sockets must be protected with residual-current-operated circuit-breakers (r. Do not drill holes into the housing to label the machine. Always lead cables away towards the back of the machine. Double insulation Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the international symbol. The machines are interference-suppressed in accordance with EN 55014. Initial operation Before the first operation check that the mains voltage corresponds to that given on the machine nameplate. 1 Switching the machine on and off The machine is started by sliding the switch ring (1) in the direction of the arrow. To do this, unscrew the locking handle (14) in a counter-clockwise direction until the curved handle (10) can be lifted out of the locking teeth of the distance holder (12). Turn the curved handle (10) to the desired position and allow it to re-engage in the locking teeth of the distance holder (12). 5 Mounting instructions for grinding and cutting discs The examples show how grinding rings are to be fastened to the spindle end with the clamping flange (18). Replacing the carbon brushes Our service personnel will carry out this and all other servicing work quickly and professionally. Before mounting tools, disconnect the machine from the power supply or remove the mains cable module (21) from the casing using the locking device button (22). This has been made very straightforward by the new mains cable module (21). Press both locking keys (22) and pull the mains cable module (21) out of the handle. Insert the new mains cable into the handle and lock in place. Different lengthed mains cables are available as special accessories. Only use the mains cable module for KRESS power tools!Do not attempt to operate other electrical appliances with it! [. . . ] Lämna tillbaka skrotade Kressmaskiner till affären eller skicka in dem till Kress. This electrical tool has been designed with high precision and was approved after undergoing strict quality control checks in the factory. We are therefore able to guarantee free servicing of any production or material faults which arise in the 24 months after the date of sale to the purchaser. We reserve the right to repair defective parts or else replace them with new parts. [. . . ]