User manual KRESS WS 800

[. . . ] Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control. Electrical safety Power tool plugs must match the outlet. Do not use any adapter plugs with earthed (grounded) power tools. [. . . ] EN Cutting discs or other cutting tools running with overspeed can fly apart and cause injuries. do not use blunt or damaged router bits. Blunt or damaged router bits cause increased friction, can become jammed and lead to imbalance. apply the machine to the workpiece only when switched on. Otherwise there is danger of kickback when the cutting tool jams in the workpiece. never cut over metal objects , nails or screws. The router bit can become damaged and lead to increased vibrations. Take protective measures if there is danger of formation of combustible or explosive dust during operation that can be hazardous to health. example: Some dusts can be carcinogenic. Wear a dust mask and work with a dust/chip extraction unit, if possible to connect. Always wait until the machine has come to a complete stop before placing it down. Use the mains cable module 7 only for Kress electric tools. Do not attempt to operate other machines with the module. damaged mains cable modules must not be used. They must be replaced by a new Kress mains cable module immediately. Push the two unlocking buttons 4 and remove the mains cable module 7 from the handle. Noise levels Measurement values determined according to EN 60 745. The A-weighted noise level of the device is typically: Sound pressure level (LpA) 78 dB(A) Sound power level (LwA) 89 dB(A) Measurement uncertainty K = 3 dB The noise level can exceed 85 dB(A) during operation. Continuous electronic control (Option) The continuous electronic control keeps the speed almost constant under no-load and under load and ensures uniform performance. Electronic control (Option) In the event of overload or overheating during continuous operation, the speed is automatically reduced until the machine has cooled sufficiently. Soft starter The starting current limitation reduces the starting current. the motor revs up slowly until it reaches the preselected rotational speed. [. . . ] Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create frequent kickback and loss of control over the power tool. Make sure that the grinding tool used is bound with ceramic or resin. When using the motor for this purpose, it is important to ensure that the motor does not exceed the maximum permissible speed for the flexible shaft. [. . . ]