User manual KRUPS 199

[. . . ] Do not use the appliance for other than intended use. Scalding may occur if the lid is removed during the brewing cycles. Do not pour liquids other than water and descaling solutions specified in this manual into the water tank. To reduce the risk of injury, do not drape cord over the counter top or table top where it can be pulled on by children or tripped over unintentionally. [. . . ] Close the thermal coffee carafe lid by twisting it tightly to the right (3). Putting in the ground coffee · We recommend that you fold over the edges of the filter paper (6) to make it easier to insert. You can purchase KRUPS size 4 paper filters (#983) or KRUPS AromaControl Gold Tone Filter (#049) at your local KRUPS retailer or by calling the KRUPS Consumer Service Department at 1-800-526-5377, 24 hours a day, 7 days a week (US customers only). Pour your ground coffee into the filter paper (7). We suggest using one level KRUPS measuring scoop of ground cofee for each cup of robust coffee. After using your KRUPS coffee maker several times, you can adjust the measure to suit your own taste. It is correctly engaged (8) and make sure the carafe with its cover closed tightly is on the thermal carafe base (4). The indicator light will illuminate and your coffee will begin brewing. "Stop `n Serve" feature The "Stop 'n Serve" feature is KRUPS answer to the impatient coffee drinker's clamor for "a quick cup of coffee!" This device automatically stops the flow of brewed coffee through the filter cone if the thermal carafe is removed from the thermal carafe base during the brewing cycle. You have about 20 seconds between the removal of the carafe and its being reinserted to pour one or two cups of coffee. The "Stop'n Serve" device closes off the filter cone so effectively that there is virtually no coffee-drip onto the thermal carafe base. Once the carafe is replaced, the brewing cycle and the flow of coffee into the carafe are resumed. If coffee does drip onto the thermal carafe base after removal of the carafe, it is usually an indication that too much ground coffee has been placed into the paper filter. This causes the water that jets into the filter cone to overflow between the paper filter and the sides of the filter cone. The overflow carries coffee grounds that interfere with the snapshut action of the filter holder, thus allowing brewed coffee to continue to drip through. If this blockage and subsequent dripping do occur, replace the carafe immediately and allow the full brewing cycle to run its course. Do not remove the filter until the brewing cycle is completed. Preparing "wake-up" coffee (model #199 and #229) This feature enables you to enjoy freshly brewed coffee at any pre-selected time within a 24-hour period. Rinse by cycling two or three more carafes of Set the hour and minutes in which you would like the brewing process to commence by pressing the "h" and "min" buttons respectively. Fill the water chamber to the desired number of cups. turn the selector switch (m) to the "Auto" setting. [. . . ] Your KRUPS #197, #199 or #229 is covered by the following warranty: If from date of purchase within one year this KRUPS product fails to function because of defects in materials or workmanship, KRUPS will, at its option, repair or replace the unit with our charge, provided the owner has a proof of date of purchase. This fine KRUPS product is manufactured according to a rigid code of quality standards, and, with minimum care, should give years of service. However, should the need arise for repairs or for replacement parts within or after the warranty period, please call our CONSUMER SERVICE DEPARTMENT: USA : Canada : (800) 526-5377 24-hours a day, 7 days a week (905) 669-0114 Monday-Friday 8:00 a. You will be provided with specific instruction on how to get your product repaired. [. . . ]