User manual KRUPS 922

[. . . ] www. krups. com c a e e1 f g b i k1 h l m n n1 k2 k4 k5 k k1 k3 d o p p1 j j1 j2 1 2 3 2 2 1 1 4 1 2 3 5 6 3 2 1 7 8 9a 9b 10 11 12 13 14 15 USA IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury, including the following: ·Read all instructions carefully. ·To protect against fire, electric shock and injury to persons, do not immerse cord, plugs, or appliance in water or other liquid. ·Close supervision is necessary when any appliance is used by or near children. ·Unplug from outlet when not in use and before cleaning. [. . . ] As soon as the appliance reaches the appropriate temperature, the indicator light (f) will illuminate. ·Now, turn the function selector (d) to the « » position. · Once the recommended quantity of coffee has been reached, turn the function selector (d) to the off position O. · Slowly remove the filter holder, as there may be a buildup of hot water still remaining in the filter, and throw away the used ESE pod by pressing the ejection button (j2) (6). 2. · If you wish to make an espresso immediately after heating or frothing, the appliance must first cool down : . place a container under the empty and correctly positioned filter holder, then turn the function selector (d) to the position « ». let water run through until the indicator light (f) goes out. Then, turn the function selector (d) to the off position O. After doing this, the machine is now ready to once again make an espresso (see paragraph «Espresso function»). Caution : Metallic portions of Auto Cappuccino system will be extremely hot immediately after use. Allow time for the appliance to cool down to prevent sclading or burning. Notes : · Store the milk container (k4) holding the unused portion of the milk in the fridge. . soup) : · Fill the water tank (b) and set the switch (e) to «I». The indicator light (e1) comes on. · Turn the steam/hot water selector (g) to the position« ». Turn the function selector (d) to the position « ». · Turn the tap (k1) to the position « ». · Immerse the nozzle (k2) into the liquid to be heated (10). If necessary, adjust the height of the grid plate support (4). The tip of the nozzle must not touch the bottom of the container so as not to prevent the passage of the steam. As soon as the appliance reaches the right temperature, the temperature control indicator light (f) comes on. · 11 Turn the function selector (d) to the position « » until the liquid is hot enough, then reset the function selector (d) to the off position O and remove the container. · For instructions on cleaning the Auto Cappuccino accessory, please refer to the paragraph «Maintenance». · As soon as the appliance reaches the right temperature, the indicator light (f) comes on. · Turn the function selector (d) to the position « ». [. . . ] Probable causes The accessories are cold (cups and filter holder). Corrective actions Pre-heat the accessories See the paragraph «Preparing an espresso». Water passes too quickly. Ground coffee too coarse. Insufficient quantity Use the spoon of ground coffee. The espresso has no crema (foam on the espresso). Try using a finer ground coffee. The appliance is not Wait for the hot enough. [. . . ]