User manual KRUPS CRYSTAL AROME PLUS 466

[. . . ] Allow to cool before putting on or taking off parts, and before cleaning the appliance. 0 Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appliance to an authorized service facility for examination, repair or adjustment. 0 The use of an accessory not evaluated for use with this appliance may cause injuries. [. . . ] 0 Hinged water container lid will protect the water from dust and dirt. 0 Water level indicator is easy to read. 0 Automatic warming plate has a non-stick coating for easy cleaning. Raised edges keep carafe firmly in place. l Hidden cord storage allows you to set the cord length you need. 1. Plug in the KRUPS "Crystal Arome Time'. Make sure the selector panel (i) is on the "off" position. The LCD display will be flashing intermittently (sea figure 1). This is your signal to set the digital clock. Turn the selector switch to position 0 . Set the hour and minutes by pressing the `h' and "min. " buttons respectively (see figure 2). Press the ON/OFF switch to the `I' position. Indicator light will illuminate and brewing will commence (see figure 101. For model #458: Turn the selector switch to the "on" position. The red indicator light will illuminate, indicating that the brewing process has begun (seefigure 11). If coffee does drip onto the warming plate after removal of the carafe, it is usually an indiction that too much ground coffee has been placed into the paper filter. This causes the water that jets into the filter cone to overflow between the paper filter and the sides of the filter cone. The overflow carries coffee grounds that interfere with the snapshut action of the filter holder, thus allowing brewed coffee to continue to drip through. H this blockage and subsequent dripping do occur, replace the glass carafe immediately and allow the full brewing cycle to run its course. Do not remove the fffter until the brewing cycle is completed. This feature enables you to enjoy freshly brewed coffee at any pre-selected time within a 24-hour period. To use this feature, you must first set the digital clock (see "Setting the Time"). 8 c 1. Turn the selector switch to the "prog. ' setting. The R symbol will flash intermittently in the display area. : 2. [. . . ] Place the carafe back on the warming plate. Turn the selector switch to the "auto. " setting (see figure 13). The R symbol will remain constant in the display, indicating that the coffee-maker has been programmed. At the pre-programmed time, the indicator light will illuminate, indicating that the brewing process has begun. [. . . ]