User manual KRUPS GRIND AROMA KM832810

[. . . ] A Coffee bean box cover B Coffee bean box C Grind and brew basket D Upper burr (grinder) E Water tank cover F Grind Adjust Knob G Display 1 Time display 2 Coffee strength indicator 3 Ground coffee indicator 4 Operating indicator 5 Number of cups indicator 6 Descaling indicator 7 Preset time indicator H Control Panel 1 On/Off button 2 On/Off indicator 3 Number of cups button 4 Coffee strength button 5 Preset time button 6 Time settings (Hour) 7 Time settings (Minute) 8 Ground coffee selection button 9 Descaling button I Water level indicator with the coffee cups' unit Please read the instructions for use carefully before using your appliance for the first time to avoid potential injury from misuse and retain them for future reference: Manufacturer cannot accept any liability for non compliant appliance use. This appliance is not intended for use by persons (including children) with Reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Do not use the appliance if the power cord or plug is damaged. [. . . ] On/Off indicator (H2) lights off after keep warm. Fill the water level that corresponds to the number of coffee cups you want to drink Put desired quantity of coffee powder into the filter. Fill water tank with desired quantity of water. Do not put coffee powder in the bean container, only in the paper filter, or it may damage your appliance. Place coffee carafe on the keep warm plate. Press the Ground coffee selection button (H8). Ground coffee indicator (G3) appears on the display. Hot water flows through the ground coffee into the carafe. When the coffee cycle is finished: ­ On/Off indicator (H2) changes from "flashes" to "lights up". On/Off indicator (H2) switches off after keep warm. Fill the water level that corresponds to the number of coffee cups you want to drink (fig. Set grinder parameters or Put desired quantity of coffee powder into the filter. Place coffee carafe (J) on the keep warm plate. Maintain the Preset time button (H5) pressed for 2 seconds. Time display(G1) will show preset timer and flash, means enter into the preset state, will exit the preset time setting state if not pressing the button within 5 seconds. Set the time using the buttons of Time settings HR (H6) to select hour. Hour value is displayed on screen (when maintaining Time settings HR (H6) pressed, hour values go faster). It will exit the Time setting state (setting time has been saved) if the button is not pressed within 3 seconds, the Preset time indicator (G7) disappears, and the Time display (G1) shows the current time. In the Preset time setting state (Preset time indicator (G7) flashes), short press Preset time button (H5) to exit the Preset time setting state (the setting time has been saved when adjusting the HR (H6) and MIN (H7) buttons), the preset time indicator (G7) disappears, and the Time display (G1) shows Current Time. In the standby state, short press Preset time button (H5), the preset time indicator (G7) flashes, the Time display (G1) flashes to show the preset time for 3 seconds, the Time display (G1) shows the current time and the preset time indicator (G7 ) light up, indicating that the machine start the preset time. Once the preset time is reached, the coffee preparation cycle starts automatically: ­ Preset time indicator (G7) disappears. Hot water flows through the ground coffee into the carafe. [. . . ] At KRUPS's choice, an equivalent or superior replacement product may be provided instead of repairing a defective product. KRUPS's sole obligation and your exclusive resolution under this guarantee are limited to such repair or replacement. Conditions & Exclusions : The international KRUPS guarantee only applies within the guarantee period and for those countries listed in the country list attached and is valid only on presentation of a proof of purchase. The product can be taken directly in person to an authorised service centre or must be adequately packaged and returned, by recorded delivery (or equivalent method of postage), to a KRUPS authorised service centre. [. . . ]