User manual KRUPS YY8201 FD

[. . . ] Com F I E P D GB NL DK N S FIN Position for 1 Position for 2 Français Nous vous remercions de votre confiance et de votre fidélité aux produits Krups. 50 English Your machine is equipped with a filter holder which boasts three exclusive systems: - One for the gradual tamping of the espresso ground coffee as the filter holder is being positioned (KTS "Krups Tamping System"). - Another is for ejecting the used grounds. It is also removable, and so can be frequently cleaned to be maintained in perfect working order. [. . . ] After using the steam function, the appliance cools automatically by pumping cold water through the heating system. During the pumping cycles, the excess steam in the heating system is released with the hot water into the drip tray. The steam and noise that accompany this phase are important for cooling the appliance. Warning: during and after using the appliance, the metal parts of the steam nozzle can become very hot. USING THE STEAM NOZZLE TO FROTH MILK Fill the water tank and turn the machine on (fig. Turn the switch to the “steam preheating” position. Move the steam nozzle towards the outside of the appliance. Pour 60 to 100ml of fresh skimmed, semi skimmed or whole milk in a small container of about 1/2 litre and which can pass under the steam nozzle. The milk and its container should be quite cold. We recommend that you use pasteurised or UHT milk and that you avoid using unpasteurised milk. As soon as the indicator lamp stops blinking, plunge the steam nozzle into the milk. Turn the switch to the “steam” position (fig. For a good result, hold the nozzle towards the bottom of the container for about 25 seconds while the milk heats (without however touching the bottom of the container). Then, bring the container down gradually so that the nozzle moves up towards the surface (without ever coming out of the milk) (fig. Once the froth has formed, turn the switch to the “stop” position (fig. The appliance will now automatically cool itself by launching 3 intermittent pumping cycles. Once this is automatic operation is complete, you can make a coffee. Important: To prevent the cappuccino accessory holes from being clogged, the milk foam must not reach the black plastic ring. It is important to clean the cappuccino accessory after each use to prevent the milk from drying on the inside. To do so: Place the cappuccino accessory in a container with water. Turn the switch to the “steam preheating” position. Once the light has stopped blinking, turn the switch to the "steam" position (to remove the remaining milk) and run the steam for 30 seconds. [. . . ] The filter holder has not been properly positioned. The edge of the filter holder is clogged by ground coffee. Stop the appliance, fill the water tank and turn the machine back on. Put the filter holder in place and lock it (by turning it to the right as far as it will go, up to the stop). [. . . ]