User manual KURZWEIL DG 150 RELEASE NOTES

[. . . ] The chain play can be stopped by pressing any button on the front panel, which puts you back into Demo mode. You can exit Demo mode by pressing the Demo button. Enhanced Full Keyboard Mode Full keyboard mode now requires you to play 3 or more notes in order to change chords. If 3 notes are played, the chord will change. Then you can "solo" over that without fear of changing chords. [. . . ] To erase this, simply turn off GM mode while the song is still selected. Any time that a song is un-selected or a new song is selected, GM mode will be turned off. The key will tell you, in kilobytes, how much memory is left in the Mark 150/10 for loading of songs and styles. When the Mark 150/10 has been reset and has no songs or styles loaded, the number is 108 kilobytes. This key lets you dump songs, styles, or panel memories via MIDI system exclusive messages. When you press C7 while in MIDI mode, the available song, style, and panel memory buttons will blink. When you press the button representing the item you want, the others will stop blinking and the dump will take place. This is an advanced MIDI feature for users with external sequencers. These users can store songs into their sequencers as system exclusive messages, and later dump them back into the Mark 150/10 for playback using the Mark 150/10's recorder. Most people do not need this feature, since the Mark 150/10 can also transfer songs to an external sequencer by playing them (using the Transmit Sequencer Data parameter), or by saving them to floppy disk. This key is used for setting the Ignore All Notes Off parameter. In the manual, it says that setting this parameter to Off may cause problems with the auto accompaniment section of the Mark 150/10. This behavior has been changed, and auto accompaniment will now work correctly with the parameter set to either ON or OFF. New MIDI Features (detail) 1. Local Control On/Off -- Controller #122. The MIDI implementation chart in the manual says that this was implemented in Version 1. 0, when in fact it was not. This has been added for better General MIDI support, but it works in all modes. This is a relatively new addition to the MIDI spec. It functions the same as All Notes Off (Controller #123). MIDI Song Select -- System Common Message $F3. Valid song numbers are 0 through 7, which would select Mark 10 sequences 1 through 8. This only responds if external sync is turned on. 910241 3 Version 2. 0 Release Notes for Kurzweil Mark 150/10 & Young Chang DG 150 MIDI Enhancements 5. Registered Parameters -- Registered Parameters 0 (Pitch Bend Range), 1 (Fine Tuning) and 2 (Coarse Tuning, which is called Receive Transpose on the Mark 10) are now supported. [. . . ] Value of 0 disables this, sending standard program changes instead. 83 84 85 86 87 88 89 90 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 910241 Sound CHOIR LAYER CATHEDRAL CHOIR 2 FAST STRINGS 3 FAST STRINGS 4 STRING LAYER STEREO STRINGS 2 EQUAL TEMPERED PIANO EQUAL TEMPERED BRIGHT PIANO SLOW STRINGS 2 GM DRUM KIT 2 ORGAN 1 ORGAN 2 SMALL DRUM KIT TIMPANI FAST STRINGS 5 PIZZICATO STRINGS TIMPANI 2 ORGAN 3 MUTED GUITAR SUSTAINED OVERDRIVE GUITAR BRIGHT PIANO* ---NOT USED--PICKED BASS FRETLESS BASS BANJO 7 Version 2. 0 Release Notes for Kurzweil Mark 150/10 & Young Chang DG 150 New Programs Prg No. 114 115 116 117 118 119 120 121 122 123 124 125 126 127 Sound SLAP BASS 2 SYNTH BASS 1 (FULL KEYBOARD) SYNTH BASS 2 (FULL KEYBOARD) TREMOLO STRINGS SHORT VOX ORCHESTRA HIT MUTED TRUMPET BRASS SECTION FINGERED BASS SYNTH BRASS 2 TENOR SAXOPHONE BARITONE SAXOPHONE 2 SAWTOOTH-WAVE WITH 5TH FANTASIA *Bright Piano (109) was formerly program number 2. Program 2 has been changed to Warm Piano in the version 2 software. 8 910241 Version 2. 0 Release Notes for Kurzweil Mark 150/10 & Young Chang DG 150 Reverb and Effect Settings Reverb and Effect Settings To change the global Reverb and Effect setting through MIDI, send a controller #83 message with a value from the following table: No. [. . . ]