User manual KURZWEIL PC2 V3.0 MUSICIANS GUIDE SUPPLEMENT REV A

[. . . ] Kurzweil PC2 Series Musician's Guide Supplement For Version 3. 0 Operating System Software April 1, 2002 ©2002 All rights reserved. Kurzweil is a product line of Young Chang Co. ; Kurzweil, PC2, PC2X, PC2R, PCX-1, and PCR-1 are trademarks of Young Chang Co. All other products and brand names are trademarks or registered trademarks of their respective companies. Product features and specifications are subject to change without notice. Part Number: 910378 Rev. [. . . ] As soon as you see Done, you can go on to the next step. If your instrument does not have the PCX-1 Polyphony Expansion option, your installations are finished, and you can do the hard reset (page 6). If your instrument does have the PCX-1 option, you'll need to install soundware objects for the PCX-1 board. Repeat Steps 4 and 5, but this time use the file pc2spnnn. mid. Press Cancel to return to the boot block menu. Do a hard reset, as described below. Doing a Hard Reset This procedure assumes that you're in the boot block menu. If you aren't, relaunch the boot block (see page 5 if you need a reminder), then proceed. Press the Left or Right cursor button until you see Hard|RESET in the bottom line of the display. The display prompts you with a question: Erase|RAM|objects?This performs the hard reset and returns you to the boot block menu. Follow the instructions in Returning to Normal Operations From the Boot Block Menu below. 6 Version 3 Software for the PC2 Installing the Version 3 Operating System Returning to Normal Operations From the Boot Block Menu 1. Press the Left or Right cursor button until you see Run|engine in the bottom line of the display. After a few seconds, you'll be back in a performance mode. You're now ready to verify the software installation. Verifying the Software Installation 1. Press the Global button to enter the menu of global parameters. Press the Right cursor button repeatedly until you see the parameter named OS Version. The version number in the display should match the version number in the name of the operating system file you installed. Press the Right cursor button repeatedly until you see the parameter named Int Sound Ver (Internal Sound Version). The version number in the display should match the version number in the name of the basic soundware objects file you installed. See the troubleshooting section below if any of the steps in the verification procedure has given you the wrong result. Troubleshooting for Software Updates You're not likely to have problems updating your software. In fact, there are very few things that can go wrong: Display is Stuck at Waiting for MIDI The MIDI signal isn't getting to the PC2. Make sure that the computer or sequencer's MIDI Out is connected to the PC2's MIDI In. [. . . ] Use the Alpha Wheel or the Minus or Plus button to select the demo to play. Press Enter to play the current song, or Cancel to return to a performance mode. The IDs of the demo sequences correspond to the banks where they're stored: 1­9 10­19 20­29 30­39 Bank 0 (Internal) Bank 1 (User) Bank 2 (Exp1) Bank 3 (Exp2) (for future release) Loading Demos into RAM You can use a standalone sequencer or a computer with sequencer software to load any PC2 demo song into RAM. PC2 demos are specialized . MID files that contain SysEx data. [. . . ]