User manual KUSSMAUL 091-12DV

[. . . ] BOOK# 091-12-1 INSTRUCTION MANUAL AUTO CHARGE 12 DV AUTOMATIC BATTERY CHARGER MODEL #091-12DV-12 NOTE : This charger is designed for vehicles with single batteries either negative or positive ground INPUT : 115/230 volt, 50/60 Hz 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO. , INC. 170 CHERRY AVE. , WEST SAYVILLE, N. Y. 11796-1221 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 INTRODUCTION This manual describes the installation and wiring for the Auto-Charge 12DV Automatic Battery Charger. It is suggested that the installer read The entire instructions to become familiar with the tasks involved before starting. INSTALLATION The installation of the vehicle wiring provides a direct connection between the battery and the Auto-Charge 12DV Automatic Battery Charger. [. . . ] A switch on the end panel of the charger selects either 115 volts or 230 volts. Set this switch to the proper position to correspond to the input voltage before applying power to the charger. Mount the charger using the four holes provided. Connect the wiring from the batteries to the Output Terminal Strip. Spade lugs that have been securely crimped or soldered should be used 3. Ring lugs that have been securely crimped or soldered should be used. Double check all wiring before proceeding. power line to the power source and check the position of the Voltage Selector Switch. The pilot light will light to show that the charger has power. The ammeter will indicate how much current is flowing to the battery. A charging current limit of 12 amperes is factory set. *************NOTE ************* DO NOT APPLY 230 VOLTS TO THE CHARGER WITH SELECTOR SWITCH IN THE 115 VOLT POSITION SERJOUS DAMAGE MAY RESULT INSTALLATION WIRING DIAGRAM WIRE SIZE CHART CONNECTION ITEM DEFINITION WIRE SIZE BATBAT+ BATTERY NEGATIVE BATTERY POSITIVE NEGATIVE CHARGING LEAD FOR BATTERIES POSITIVE CHARGING LEAD FOR BATTERY # 1 NEGATIVE VOLTAGE SENSE LEAD. DETECTS VOLTAGE POSITIVE VOLTAGE SENSE LEAD. DETECTS VOLTAGE 14 AWG 14 AWG 16 AWG 16 AWG IMPORTANT: Wire size is for a maximum length of 20 feet. [. . . ] Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. [. . . ]