User manual KUSSMAUL 091-53-REMOTE

[. . . ] FILE: 091-53-12-REMOTE DATE: 12-16-2005 REV: C INSTRUCTION MANUAL AUTO CHARGE 1200 REMOTE AUTOMATIC BATTERY CHARGER MODEL #091-53-12-REMOTE INPUT :115 volt, 50/60 Hz, 10 amps OUTPUT: 40 AMPERES 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO. , INC. 170 CHERRY AVE. , WEST SAYVILLE, N. Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 INTRODUCTION The AUTO CHARGE 1200 is a compact, completely automatic, single channel battery charger designed for vehicles with a single battery system. [. . . ] During this brief interval the Auto Charge 1200 measures and stores the battery voltage. This battery voltage is compared to a standard and any error is detected and used to control the charger output at the desired level. Their is no "trickle charge" and therefore no danger of overcharging and water boil-off. Automatic Current Limiting When batteries are severely discharged, some battery chargers can be overloaded due to the high charging current required. The Auto Charge 1200 contains an automatic current limit. This circuit limits the output current to the rated 40 amperes when charging a deeply discharged battery or if the starter cranks the engine while charging. The current limiter thus eliminates the need for an ignition interlock circuit. Battery Charge Condition Indicator This indicator shows the charge condition of the battery in 10 levels from "LOW CHARGE" to "FULLY CHARGED". This device indicates a defective battery when a bar graph does not rise to the "FULLY CHARGED" level after an extended period of charging. NOTE: If a battery is being charged with an external load of 4 to 10 amperes across it's terminals, the bar graph may move down 1 or 2 levels. This does not indicate a defective battery. Installation Wiring Diagram INDICATOR NOTE INDICATOR WIRING PIN 1 OF INDICATOR MUST GO TO PIN 1 OF CHARGER, PIN 2 OF INDICATOR MUST GO TO PIN 2 OF CHARGER AND SO FORTH PLEASE CHECK CONNECTIONS AND COLOR OF WIRES BEFORE PLUGGING IN. AUTO CHARGE 1200 POWER REMOTE DISPLAY WHT BLK RED FUSE OUTPUT + USE 8 AWG or larger on Output & Gnd IMPORTANT: WIRE SIZE IS FOR A LENGTH OF 10 FEET. IF WIRING IS TO BE LONGER, 6 AWG WIRING IS REQUIRED, ADDITIONAL INFORMATION IS AVAILABLE ON REQUEST. Chassis Ground Chassis Ground Specifications: Input: 115 volt, 50/60 Hz, 10 amperes Input Fuse: 15 ampere, fast acting Output: 12 volts D. C. [. . . ] shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. [. . . ]