User manual KUSSMAUL 091-84

[. . . ] A novel plug detector closes and opens the 120 volt A. C. circuit after the mating connector is inserted and before the connector is ejected. This eliminates arcing at the connector contacts and assures long contact life. [. . . ] This eliminates arcing at the connector contacts and assures long contact life. As with all Auto Ejects, the Super 30 Auto Eject is connected to the starter circuit so that ejection occurs when the engine is cranked. INSTALLATION INSTRUCTIONS Step #1 wiring unit 1. Remove rear plastic cover from Super 30 Auto Eject by unscrewing (4) #8-32 screws. Snake wires though small cover strain relief and install wires as shown use 18 AWG wire minimum. Snake wires though large cover strain relief and install wires as shown use 10 AWG wire minimum. Test the unit to see if it is operational before mounting. 3. 4. Locate a convenient place on the vehicle to mount the AUTO EJECT. A minimum clearance of 5 inches behind the mounting panel is required. Kussmaul Electronics does not warrant the connector. ABOUT CONNECTORS The Super 30 Auto Eject is supplied with mating connector. We suggest that you utilize the connector supplied. When replacing with another connector, test carefully that the new connector will eject properly. TORQUE SCREWS TO 16 LB-IN 10 AWG MINIMUM GROUND NEUTRAL TO AC LOAD ON VEHICLE LINE BACK OF SUPER 30 AUTO EJECT WITH REAR PLASTIC COVER REMOVED 3 CONDUCTOR 10 AWG MINIMUM STRIP WIRES 5" FROM OUTER JACKET UNLESS OTHERWISE SPECIFIED: DIMENSIONS ARE IN INCHES TOLERANCES DECIMALS ANGULAR WEST SAYVILLE, NY . XX . XXX DRAWN DO NOT SCALE DRAWING + + - . 005 . 001 FIGURE 2 AC WIRING SIZE DW G NO. T. Nugent 091-159 REV FINSH MAT: SCALE DATE SHEET OF CONNECTOR ON PC BOARD NOTE: FUSE 3 AMP FUSE FOR 12 VOLT 2 AMP FUSE FOR 24 VOLT PC BOARD + 12 VOLTS CONTINUOUS GROUND TO STARTER FUSE 3 CONDUCTOR 18 AWG WIRE TOP OF SUPER 30 AUTO EJECT WITH REAR PLASTIC COVER REMOVED UNLESS OTHERWISE SPECIFIED: DIMENSIONS ARE IN INCHES TOLERANCES DECIMALS ANGULAR WEST SAYVILLE, NY . XX . XXX DRAWN DO NOT SCALE DRAWING + + - . 005 . 001 FIGURE 3 DC WIRING SIZE DW G NO. Nugent FINSH 091-159 SCALE DATE SHEET OF MAT: 4. 190 1. 010 6. 210 0. 330 4. 676 1. 475 0. 250 4. 735 1. 282 6. 123 8. 874 0. 500 5. 356 . 42 UNLESS OTHERWISE SPECIFIED: DIMENSIONS ARE IN INCHES TOLERANCES DECIMALS ANGULAR WEST SAYVILLE, NY . XX . XXX DRAWN DO NOT SCALE DRAWING + + - . 005 . 001 OUTLINE DRAWING SIZE DWG NO. Nugent FINSH 091-159 SCALE DATE SHEET OF MAT: 1 YEAR WARRANTY All Super 30 Auto Ejects manufactured by Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equipment was shipped. [. . . ] are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equipment was shipped. Equipment is to be returned, shipping charges prepaid and will be returned, after repair, shipping charges paid. [. . . ]