User manual KYOCERA DF-600

[. . . ] ALWAYS read this Operation Guide thoroughly before use. After reading, maintain it in good condition and keep it together with the Operation Guide for your copier. DF-600 is written as Single-staple model and DF-610 is written as Double-staple model. ALWAYS read this Operation Guide thoroughly before use. [. . . ] In this case, remove all copies from Tray A and Tray B. * The maximum number of copies that can be stored on the Tray A and the Tray B will differ depending on the size of copy paper that is being used. Remove all of the finished copies from the Tray A. * Refer to the Operation Guide of your copier for more detailed information on selecting the desired copy mode. * Stapling capacity: <Upper left, single staple> 11"x17", 8 1/2"x14", A3, B4: 30 sheets 8 1/2"x11", 11"x8 1/2", A4, A4R, B5: 50 sheets <Upper right, single staple> (Double-staple model only) 11"x17", 8 1/2"x14", A3, B4: 30 sheets 8 1/2"x11", 11"x8 1/2", A4, A4R: 50 sheets * When setting an original on the platen, a message will appear after each original is scanned to confirm whether you want to scan another original or not. Refer to the Operation Guide of your copier for further details. Select the desired paper size and copy exposure, etc. * In this case, finished copies will be ejected face down. In this case, remove all copies from the Tray A. * The maximum number of copies that can be stored on the Tray A will differ depending on the size of copy paper that is being used. Remove all of the finished copies from the Tray A. Select the Interrupt copy mode on the operation panel of your copier and perform the appropriate procedure to start copying. * Refer to the Operation Guide of your copier for more detailed information on the Interrupt copy mode. Replace the present original(s) with the one(s) to be copied. Select the desired paper size and number of copies to made, etc. After Interrupt copying is completed, perform the required operation on your copier to release the Interrupt copy mode. The copy job that was interrupted will then resume. * The Single-staple model is equipped with a Staple holder A, and the Double-staple model is equipped with a Staple holder B and Staple holder A. The procedures for adding staples and removing staple jams are the same in the two models. * If the staples run out, contact your service representative. Refilling the Stapling unit If a message appears on the copier indicating that staples have run out, the staple holder(s) need to be replenished with staples. Grasp the front cover handle and open the front cover towards you. [. . . ] Paper jam in the ejection section of optional Center-folding unit If the display shown in the figure above appears on the operation panel of the copier, there is a paper jam in the ejection section of the Center-folding unit. Grasp the front cover handle and open the front cover towards you. Turn the Unit release lever, and hold the Unit release handle to move the Center-folding unit in the paper ejection direction. If the paper is not easy to remove, turn the Conveyor guide knob 3 to feed the paper to a location where the paper can be easily removed, and remove the paper. [. . . ]