User manual KYOCERA DP-1800

[. . . ] DP-1400 DP-1800 INSTRUCTION HANDBOOK Please read this instruction handbook before using the printer. Keep it close to the printer for easy reference. Laser Printer Introduction Please read this instruction handbook before using the printer. Keep it close to the printer for easy reference. The sections of this handbook and parts of the printer marked with symbols are safety warnings meant to protect the user, other individuals and surrounding objects, and ensure correct and safe usage of the printer. [. . . ] Then turn the printer's power off and on again. The setting will be activated after restart. RAM DISK Operations The following operations are available with the RAM DISK. Read Data Write Data Delete Data Print a List of Data Names Procedures for all operations are the same as for a memory card. Please see the memory card item for the given procedure. 2-14 2. 6. Operating a Memory Card 2. 6. Operating a Memory Card Hints on Writing Fonts to the Memory Card Some memory card writer utility programs are available for writing data to the memory card. If you write fonts into a memory card, we recommend you write them as font data and not as host data. Fonts written in a memory card as font data are automatically loaded in the printer when it is switched on and are usable on all the printer interfaces simultaneously. The printer reads only the header part of these fonts into its memory and therefore these fonts do not occupy a large area in the printer's memory. If you write the fonts in the memory card as host data, the fonts are transferred directly from the memory card into the printer's memory when the card is read. This may require extra memory to be installed in the printer as they usually occupy a great amount of the printer's memory. Moreover, use of the fonts is restricted on only the interface that was active during the fonts were read from the memory card. To properly write font data into the memory card, refer to the memory card writer manufacture's instructions. Reading Fonts/Data from a Memory Card If the memory card is already inserted in the slot when the printer is powered on, the fonts are automatically read into the printer. To reread the fonts from a memory card, use the >Read fonts function. The PRESCRIBE 2e FRPO I0 command specifies the name of the partition in the memory card to be read automatically at power up. See PRESCRIBE 2e Programming Manual, Chapter 5. Writing Data to a Memory Card A memory card can hold up to 127 data partition names, depending on its capacity. When writing to the card, a name is assigned automatically. You can use the procedure later in this section to print a list of data names for confirmation. You cannot write font data to a memory card with the printer. To write data to a memory card, proceed as follows. First check that the memory card can be writable (that the memory card is properly formatted, not writeprotected, and its internal battery is not exhausted, for example). Otherwise, the >Write data message to be explained below will not be shown on the message display. If the card inserted in the memory card slot is not formatted, the >Format option will automatically appear on the display. Refer to Formatting a Memory Card which follows this section and format the memory card. 1. With the message display showing >Write data, press the ENTER key. A blinking question mark will appear as follows: >Write data ? 2. The message display changes to show Processing, then to Waiting. If you want to abandon writing, press the CANCEL key. 3. [. . . ] MITA NE SERA PAS TENU RESPONSABLE DES DOMMAGES DIRECTS OU INDIRECTS QUI POURRAIENT SURVENIR SUITE À L'UTILISATION OU À L'IMPOSSIBILITÉ D'UTILISATION DE L'IMPRIMANTE. MITA COPYSTAR AMERICA, INC. 225 Sand Road, P. O. Box 40008, Fairfield, New Jersey 07004-0008, U. 1-800-255-6482 MITA COPYSTAR CANADA, LTD. 6120 Kestrel Road, Mississauga, Ontario L5T 1S8, Canada 1-800-268-4735 * La garantie ci-dessus est valable seulement aux Etats-Unis et au Canada. This page is intentionally left blank MITA COPYSTAR AMERICA, INC. Headquarters: 225 Sand Road, P. O. Box 40008 Fairfield, New Jersey 07004-0008 TEL: (973) 808-8444 FAX: (973) 882-6000 New York Show Room: 149 West 51st street New York, NY 10019 TEL: (212) 554-2679 FAX: (212) 554-2625 Northeastern Region: 225 Sand Road, P. O. [. . . ]