User manual KYOCERA KM-4800W

[. . . ] KM-4800w Copy/Scan Operation Manual NOTE: This Operation Manual contains information that corresponds to using both the metric and inch versions of these machines. The metric versions of these machines are shown in the screens in this Manual. If you are using the inch version, use the messages provided for the metric version as reference only. In the body text, only the metric messages are given if these versions differ only in capitalization. [. . . ] Press the L2 Key repeatedly for the shifting value of Stamp image. Stamp image is shifted to the center when X is increased. Stamp image is shifted to the trailing edge side when Y is increased. Each the setting ranges for both X and Y is 0 to 100 millimeters in increments of 1 millimeter. Press the R2 Key to specify the font size. The input range is from 8 to 16pt in 1pt increment. Ex. ) Mon Jul 14 21:22:05 2008 Press the Enter Key to apply the setting. 3. 3. 7. 13 Negative Image To make a negative image print, press the R4 Key or L4 Key in Advanced Settings Screen to enter Advanced Settings 3 Screen. Press the R2 Key repeatedly to choose "ON" or "OFF". Choose ON to make a negative image print. Press the Enter Key to apply the setting. 30 3. 3. 7. 14 Original Width Setting To specify the original width to be scanned, press the R4 Key or L4 Key in Advanced Settings Screen to enter Advanced Settings 3 Screen. Press the R3 Key to enter Original Width Setting. "Auto" can be used in most cases. Press the L1 Key and R1 Key to select the original width from preset width Press the L2, R2 Key to enter a given width manually in "Width Entry" with the Numeric Keys. Width Entry covers 279 to 914mm in increments of 1 millimeter. The selection of "Original Width" differs depending on the current Size Format. DIN: Auto, 297mm, 420mm, 594mm, 841mm, 36", Width Entry DIN Extra: Auto, 297mm, 420mm, 594mm, 880mm, 36", Width Entry ENG: Auto, 11", 17", 22", 34", 36", Width Entry ARCH: Auto, 12", 18", 24", 30", 36", Width Entry Press the Enter Key to apply the setting. 31 3. 4 About Toner Empty Replace the toner cartridge when "Toner empty" is displayed. Additional copy or print is still available in an emergent case without replacing with the new toner cartridge when the following Fig. 1 message is displayed. Press any key (except Stop Key) in this case to continue copying or printing. When the following Fig. 2 message is displayed after that, no more copy or print is available. Fig. 2 message may be displayed directly skipping Fig. 1 message if a large volume of copy or print is made when few toner is left in the cartridge. Replace the toner cartridge as no more additional copy or print is available. Fig 1 Fig 2 32 3. 5 About Maintenance Message The following message is displayed when maintenance is required. [. . . ] 5. 2. 6. 2 Change User Password To change the user password, press the L2 Key in User Mode Screen to enter Change Password Screen. Press the R1 Key to focus the current password. Press the R2 Key to focus a new password. Press the R3 Key to focus the new password confirmation. The message shown below is displayed with a successful authentication. Press the Enter Key. [. . . ]