User manual KYOSHO MINI-Z OVERLAND

[. . . ] Before beginning assembly, please read these instructions thoroughly. Safety Precautions Content Equipments not included Glossary of Main Parts Before Operating Let's Drive!*Specifications are subject to change without prior notice!The increased processing speed of the RA-18M receiver amp unit delivers significantly faster response and the use of high-efficiency FET contributes to sharp acceleration. [. . . ] Once the LED indicator comes on, stop pushing the Pairing Button. Light is ON : Pairing has been successful Light is flashing : Pairing has not be completed. Push the transmitter power button again and to turn it off. Setting takes effect the next time power is turned on. Appliances such as a microwave oven are emitting strong electrical waves are being used close by. Carefully spread the sides of the body over the chassis mounts. Push the power button to turn transmitter on. 4GHz Mini-Z Series models can be run but may be lower if other 2. If no frequency can be found, LED will not light. Wheels may spin freely when power is turned on. Always turn the transmitter's power switch ON first!With throttle trigger in neutral, click Throttle Trim one click at a time until car stops and continuous beep stops. Adjustment not needed if car doesn't move. Beeping sound will start when neutral is found or range limit is reached. If chassis is moving in reverse, click this button. If chassis is moving forward, click this button. Raise the tires off the ground and check that all controls are responding. Raise the tires off the ground and check hat all controls are responding. Raise the tires off the ground and check that all controls are responding. When Throttle Trigger is in neutral and the car hasn't stopped moving, follow the steps below to adjust neutral position. Check if a continuous beep sound is coming from the chassis. Beep sound but car is moving backwards. [. . . ] 10T Pinion Gear should always go with the Spacer. For replacement, refer to the chart and use proper combination with pinion and spacer. This receiver is the first RC to be equipped with an interactive data communication function with a personal computer. This enables machine settings to be done externally through the computer. [. . . ]