User manual LA CROSS TECHNOLOGY TX7U

[. . . ] Transmission problems will arise if this is not done correctly and if the total time for setup exceeds 6 minutes. BATTERY INSTALLATION Follow these directions when first setting up, when replacing batteries, or for resetting purposes. Remove the batteries from all existing display units in operation. Using a screwdriver, unscrew and open the battery cover located at the front of the outdoor temperature/humidity sensor. Battery compartment Battery cover Note: Outdoor temperature/humidity sensors will not usually read the same temperature. [. . . ] Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. 5. Snap the outdoor temperature/humidity sensor into place on the mounting bracket. B. MOUNTING WITH ADHESIVE TAPE 1. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. Remove the protective strip from one side of the tape. Press firmly into the designated area on the back of the mounting bracket. Remove the protective strip from the other side of the tape, and position the outdoor temperature/humidity sensor in the desired location. MOUNTING USING THE BRACKET AS A STAND The mounting bracket can be used as a stand by simply attaching the bracket to the bottom of the temperature/humidity sensor. Once snapped in place the sensor can then be placed on a shelf, table or other surface where the temperature and humidity measurements are desired. C. III. MAINTENANCE AND CARE 1. Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units 2. Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents, they may mark the displays and casings 3. Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. Opening the casings invalidates the warranty. Contact La Crosse Technology for repairs. SPECIFICATIONS Temperature measuring range Relative Humidity measuring range Transmission interval Transmission frequency Power source Dimensions (H x W x D) -21. 8ºF to 157. 8ºF with 0. 2ºF resolution (-29. 9°C to 69. 9°C) 1% to 99% with 1% resolution) Every 10 seconds in first 3 minutes Every 1 minute thereafter 433. 92 MHz 2 x 1. 5V AA Battery Alkaline recommended 6. 3" x 2. 95" x 2. 2" (160 x 75 x 55mm) IV. V. LIABILITY DISCLAIMER 1. The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any consequences occurring should an inaccurate reading take place. This product is not to be used for medical purposes or for public information. The specifications of this product may change without prior notice 4. No part of this manual may be reproduced without written consent of the manufacturer. WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. [. . . ] For warranty work, technical support, or information contact: La Crosse Technology 2809 Losey Blvd. La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 e-mail: support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. [. . . ]