User manual LA CROSS TECHNOLOGY WS-7032U

[. . . ] After both indoor and outdoor temperatures are displayed for 10 minutes you can place your sensor outdoors and set your time. 4 The remote sensor should be placed in a dry, shaded area. The remote sensor has a range of 80 feet. Any walls that the signal will have to pass through will reduce distance. [. . . ] It will not change from "sunny" directly to "rainy, " although it is possible for the change to occur quickly. If the symbols do not change then the weather has not changed, or the change has been too slow and gradual to register. WEATHER TENDENCY ARROWS Other possible displays in the FORECAST LCD are 2 weather tendency arrows, one that points up (under the forecast icons) and one that points down (above the forecast icons). These arrows reflect current changes in the air pressure. An arrow pointing up indicates that the air pressure is increasing and the weather is expected to improve or remain good, an arrow pointing down indicates that the air pressure is decreasing and the weather is expected to become worse or remain poor. OUTDOOR TEMPERATURE The Weather Temperature Station receives the outdoor temperature (°F or °C) from the Remote Temperature Sensor, and the temperature appears in the OUTDOOR LCD. The Remote Temperature Sensor makes a temperature update every 1 minute, and transmits a new temperature to the Weather Temperature Station 3 times every 10 minutes. MOUNTING 10 Note: Extreme and sudden changes in temperature will decrease the accuracy of the Weather Temperature Station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Temperature Sensor. We recommend that you mount the Remote Temperature Sensor on a North-facing wall. The sending range is 80ft (25m)--obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location, and wait approximately 10 minutes before permanently mounting to ensure that there is proper reception. The Weather Temperature Station should display a temperature in the OUTDOOR LCD within 3 minutes of setting-up. THE REMOTE TEMPERATURE SENSOR The Remote Temperature Sensor can be mounted in two ways: · with the use of screws, or · using the adhesive tape. Remove the mounting bracket from the Remote Temperature Sensor. Place the mounting bracket over the desired 2. 11 3. Through the three screw holes of the bracket, mark the mounting surface with a pencil. Where marked, start the screw holes into the mounting surface. Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. Snap the Remote Temperature Sensor onto the mounted bracket. MOUNTING WITH ADHESIVE TAPE 1. [. . . ] To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. [. . . ]