User manual LA CROSS TECHNOLOGY WS-7107U

[. . . ] WS-7107U Wireless 433 MHz Weather Station Instruction Manual TABLE OF CONTENTS Topic Inventory of Contents Additional Equipment Quick Setup Detailed Setup Guide Battery Installation Setting the Weather Station Features Minimum and Maximum Temperatures Resetting Minimum and Maximum Temperatures Adding additional remote temp/humidity sensors (optional) Viewing and operating multiple remote temp/humidity sensors Mounting Troubleshooting Maintenance and Care Specifications Warranty Information Page 3 4 5-8 9-11 11-12 13 14 14-16 17-18 18-19 20-23 23 24-25 26-31 2 INVENTORY OF CONTENTS 1. Two indoor weather station (Figure 1) 2. The remote temperature/humidity sensor (TX7U) and mounting bracket. Instruction Manual and Warranty Card. Figure 1 Figure 2 3 ADDITIONAL EQUIPMENT (not included) 1. [. . . ] ADDING ADDITIONAL REMOTE TEMP/HUMIDITY SENSORS (OPTIONAL) The WS-7107U is able to receive signals from 3 different remote temperature, temperature/humidity sensors. Following are some brief instructions for the basic 13 set-up of remote sensor units with the WS-7107U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6 will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, the TX3UP will monitor the temperature via a probe for use in pools, spas, etc and the TX4U or TX7U will monitor temperature and humidity. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temp/humidity sensor units, and in numeric sequence. Second, install batteries into the indoor weather station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. 14 1. It is necessary to remove the batteries from all units currently in operation. 2. Remove the battery covers to all remote sensor units. 3. Place all remote sensor units in a numeric sequential order. 4. In sequential order, install batteries (follow the same battery installation procedures seen in section "I" of the Detailed Set-Up Guide) into the remote sensors. Install batteries into the indoor weather station. Follow the Detailed Set-Up Guide for programming and operating instructions. 15 D. VIEWING AND OPERATING WITH MULTIPLE REMOTE SENSOR UNITS 1. To view the temperature of a different remote sensor unit, press and release the "CH" button. A shift from one "boxed" number to the next should be observed in the OUTDOOR LCD. 2. To view the Minimum/Maximum temperature: first select from which remote temp/humidity sensor to read data from (indicated by the "boxed" number). Pressing and releasing the "MIN/MAX" button will toggle through the minimum and maximum indoor temperature, and the minimum and maximum outdoor temperature. 16 3. To reset the Minimum/Maximum readings, press and hold the "MIN/MAX" button for five seconds. MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temp/humidity sensor on an outside Northfacing wall. The sending range is 330ft; obstacles such as walls, concrete, and large metal objects will reduce the range. [. . . ] Do not use solvents or scouring agents; they may mark the displays and casings. Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. Opening the casings invalidates the warranty. Contact La Crosse Technology for repairs. · · · 22 SPECIFICATIONS Transmitting 433MHz Frequency Measuring Range - Temperature Indoor Weather 32°F to 138. 2°F Station: Indoor (0. 0°C to 59°C) with 0. 2°F (0. 1°C) resolution. [. . . ]