User manual LA CROSS TECHNOLOGY WS-7136U

[. . . ] WS-7136U Wireless 433 MHz Temperature Station Instruction Manual TABLE OF CONTENTS Topic Inventory of Contents Additional Equipment Quick Setup Detailed Setup Guide Battery Installation Setting the Time Format Setting the Temp. Format Setting the Time Features Minimum and Maximum Temperatures Resetting Minimum and Maximum Temperatures Adding additional remote temperature sensors (optional) Viewing and operating multiple remote temperature sensors Mounting Troubleshooting Maintenance and Care Specifications Warranty Information Page 3 4 5-9 10-12 13 13-14 14-15 16-17 17 17-19 20 21-22 23-26 26 27-28 28-31 2 INVENTORY OF CONTENTS 1. The indoor Figure 1 temperature station (Figure 1) 2. The remote temperature sensor (TX6U) and mounting bracket. [. . . ] Press and release the "RESET/+" button to set the minutes. Press and release the "SET" button to advance to the time setting or wait 15 seconds for the display to return to the normal mode. Note: There is "PM" displayed to the left of the hour when between noon and midnight. During the AM hours this area will be blank. 15 FEATURES A. Press and release the "MIN/MAX" button, "MIN" appears above and to the right of each temperature and the recorded minimum temperatures are displayed along with the time of the recorded minimum outdoor temperature. Press and release the "MIN/MAX" button to toggle to the maximum temperatures, "MAX" appears above and to the right of each 16 temperature and the recorded maximum temperatures are displayed along with the time of the recorded maximum outdoor temperature. Please note that the flashing time is the time of the recorded outdoor temperature minimum or maximum. B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES To reset both the minimum and maximum temperatures--press and hold the "MIN/MAX" button for 5 seconds. C. ADDING ADDITIONAL REMOTE TEMPERATURE SENSORS (OPTIONAL) The WS-7136U is able to receive signals from 3 different remote temperature sensors. Following are some brief instructions for the basic set-up of 17 additional remote sensor units with the WS-7136U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, the TX3UP will monitor the temperature via a probe for use in pools, spas, etc. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensor units, and in numeric sequence. Second, install batteries into the indoor temperature station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. 18 1. It is necessary to remove the batteries from all units currently in operation. 2. Remove the battery covers to all remote sensor units. 3. Place all remote sensor units in a numeric sequential order. 4. In sequential order, install batteries (follow the same battery installation procedures seen in section "I" of the Detailed Set-Up Guide) into the remote sensors. Install batteries into the indoor temperature station. Follow the Detailed Set-Up Guide for programming and operating instructions. 19 D. VIEWING AND OPERATING WITH MULTIPLE REMOTE SENSOR UNITS 1. [. . . ] The original dated bill of sale must be presented upon request as proof of 28 purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. [. . . ]