User manual LA CROSS TECHNOLOGY WS-9014U

[. . . ] DO NOT PRESS ANY BUTTONS FOR 10 MINUTES. 4 1. In this time the indoor temperature station and remote temperature sensor will start to talk to each other and the display will show both the indoor temperature and an outdoor temperature. If the indoor temperature station does not display both temperatures after the 10 minutes please retry the set up as stated above. After both indoor and outdoor temperatures are displayed for 10 minutes you can place your remote temperature sensor outdoors and set your time. [. . . ] Press and release the "SET" button again, "°F" will appear in the TIME LCD. Press and release the "MIN/MAX" button to shift between °F and °C. Press and release the "SET" button twice to activate settings. 12 IV. Press and release the "MIN/MAX" button, "MIN" appears in the temperature LCD's and the recorded minimum temperatures are displayed. Press and release the "MIN/MAX" button to toggle to the maximum temperatures. The time of occurrence of the value for outdoor temperature will also flash. B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES 1. To reset both the minimum and maximum temperatures--press and hold the "RESET/+" button for 4 seconds. C. ADDING ADDITIONAL REMOTE TEMPERATURE SENSORS (OPTIONAL) 13 1. The WS-9014U is able to receive signals from 3 different remote temperature sensors. Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-9014U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6 will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP will monitor the temperature via a probe for use in pools, spas, etc. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensor units, and in numeric sequence. Second, install batteries into the indoor temperature station. Transmission problems will arise if this is not done correctly and if 14 the total time for set-up exceeds 6 minutes. It is necessary to remove the batteries from all units currently in operation. Remove the battery covers to all remote temperature sensor units. Place all remote temperature sensor units in a numeric sequential order. In sequential order, install batteries (follow the same battery installation procedures seen in section "I" of the Detailed Set-Up Guide). Install batteries into the indoor temperature station. Follow the Detailed Set-Up Guide for programming and operating instructions. D. [. . . ] Opening the casings invalidates the warranty. Contact La Crosse Technology for repairs. · · · 20 SPECIFICATIONS Transmitting 433MHz Frequency Measuring Temperatures Indoor 32°F to 156. 2°F with Temperature 0. 2°F resolution. Station: Indoor (0°C to 69. 0°C with 0. 1°C resolution) Indoor -21. 8 °F to 156. 2°F with Temperature 0. 2°F resolution. Station: Outdoor (-29. 9°C to 69. 0°C with 0. 1°C resolution) Temp accuracy +/- 1°F (+/- . 5°C) Transmitting Maximum 80 feet (25m) range open space Temperature check Indoor Every 10 seconds Outdoor Three times in 10 minutes Batteries--(Alkaline recommended) 2 x AA, 1. 5V Remote Temperature Sensor 21 Indoor Temperature Station 2 x AAA, 1. 5V Dimensions: (L x W x H) Indoor 2. 36 x 0. 88 x 5. 90 in. [. . . ]