User manual LA CROSS TECHNOLOGY WS-9057U

[. . . ] WS-9075U Wireless 433 MHz Radio-controlled Weather Station Instruction Manual TABLE OF CONTENTS Topic Inventory of Contents/Additional Equipment About WWVB Quick Set-Up Guide Detailed Set-Up Guide Battery installation Program Mode Program Sequence and Default Settings Function Keys Setting the LCD Contrast Setting the Time Zone Daylight Saving Time Setting Radio-controlled Time Setting On/Off 12/24-hour Time Setting Setting the Time Setting the Year, Day and Month Setting the Temperature Unit Setting the Forecast Sensitivity Setting the Animation (Weather Icons and Stars) Features Weather Forecast Icons and Tendency Arrows Outdoor Temperature(s) Indoor Temperature Minimum & Maximum Records (Indoor, Outdoor, & Resetting) Outdoor Channel Re-learn Mode Moon Phase Time Alarm Adding Remote Temperature/Humidity Sensors (Optional) Mounting Troubleshooting Maintenance & Care Specifications Warranty Information Page 3 3 4 5 6 6 6 7 7 8 8 8-9 9 9 9 10 11 11 11 12 13 13 13 14 15-16 16 17 17 18-19 2 INVENTORY OF CONTENTS 1. The WS-9075U weather station (Figure 1) 2. One TX6U remote temperature sensor (Figure 2) 3. Figure 1 Time and Date LCD Figure 2 Forecast LCD Remote Temperature Sensor Outdoor LCD Indoor LCD Moon Phase LCD *LCD (Liquid Crystal Display) ADDITIONAL EQUIPMENT (not included) 1. [. . . ] To achieve a true temperature reading, avoid mounting where direct sunlight can reach the remote temperature sensor or indoor weather station. While the remote temperature sensor is weather proof, avoid submersion in water or snow. We recommend that you mount the remote temperature sensor on an outside North-facing wall. The sending range is 330ft--obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location, and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. The indoor weather station should display a temperature in the OUTDOOR LCD within 4 minutes of setting up. THE REMOTE TEMPERATURE SENSOR The remote temperature sensor can be mounted in two ways: · with the use of screws, or · using the adhesive tape. MOUNTING WITH SCREWS 1) Remove the mounting bracket from the remote temperature sensor. 2) Place the mounting bracket over the desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. 3) Where marked, start the screw holes into mounting surface. 4) Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2) Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket. 3) Remove the protective strip from the other side of the tape. Position the remote temperature sensor in the desired location, ensuring that the indoor temperature station can receive the signal. THE INDOOR WEATHER STATION The indoor weather station can be mounted in several ways: · With the use of screws · Using its foldout stand A. MOUNTING WITH SCREWS 1) Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall. 2) Place the indoor weather station onto the screw using the hanging hole on the backside. [. . . ] To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of 23 purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. [. . . ]