User manual LA CROSS TECHNOLOGY WT-2191

[. . . ] SETTING THE TIME There are two methods by which the time and date can be set: 1) Automatically via WWVB reception, or 2) Manually. B. WWVB (Radio-Controlled Time) This method requires you to do nothing, except wait for the signal to be received, and to select a time zone. Reception usually takes approximately 6-10 minutes during optimal conditions. The best conditions for reception is at night, between midnight and 6:00 am--when there is less atmospheric interference. [. . . ] Press the "+" key to advance to the correct day. i) The day of the week will now flash (Sun, Mon, etc. ). Press the "+" key to advance to the correct day of the week. j) "12" or "24" will now flash. Press the "+" key to select either 12 ­hour or 24hour (military time). PROGRAMMING SEQUENCE Time ZoneDST On/OFFSnooze SettingHourMinuteYearMonth DateDay12/24 hour format 8 III. SETTING THE ALARMS La Crosse Technology's travel alarm clock has two separate alarms that can be set. Each alarm has a distinctive sound and operate independently. Press and hold the "ALM1" (or "ALM2" key) key for two seconds to enter the setting mode. Press the "HOUR" key to advance the hour of the alarm, and press the "MIN" key to advance the minutes of the alarm. If no button is pressed within fifteen seconds, the alarm will set and will activate, and the clock will revert to the normal operating screen. The picture below shows both alarms activated. B. To activate/deactivate the alarm, press "Alarm 1" activated "Alarm 2" activated 9 the "ALM1" or "ALM2" key once, depending on which alarm needs to be activated. When the alarm is sounding, pressing the "SNOOZE" will turn it off for the time that was selected in the programming mode (section II. A. 2. c. ). The snooze is activated by pressing back on the entire unit while the cover is open. The actual button is on the bottom of the unit and is pressed by the cover when pushed back. If the setting is "0", the alarm will turn off for 24 hours. During the snooze period, the lower screen will show a countdown until the alarm will sound again. If the snooze bar is pressed again during the original snooze period, the period will be reset. Once the period is finished, the alarm will sound again. Pressing any key other than the snooze key will turn off the alarm for 24 hours. 10 IV. The exact time will always be displayed in the upper portion of the screen, and the US map will show when the time zone is set to the continental US (with the time zone selected showing in black). [. . . ] The clock will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the alarm clock inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF 15 THIS ALARM CLOCK. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. [. . . ]