User manual LA CROSS TECHNOLOGY WT-3132LCD

[. . . ] The "°F/ °C" will be flashing, use the + key to toggle between "°F" and "°C". Once the desired temperature unit has been chosen, confirm with the SET to advance to the 12/ 24 hr time format. 12/ 24 HR TIME FORMAT flashing The time display can be selected to show hours in 12-hour or 24-hour settings. Press the + key to toggle between "12H" or "24H". [. . . ] Your clock can only set itself to one of the four time zones stated above. For time zones outside of PT, MT, CT or ET you must manually set the time using the Manual Time set button on the back of the movement. Our clock will set to the correct Time Zone that you selected. Once the clock has reached the correct time, you are ready to hang your clock. ONCE THE CLOCK HAS SET TO THE DEFAULT PACIFIC TIME ZONE, YOU MUST PRESS THE CORRECT TIME ZONE BUTTON. The clock is designed for indoor use only. Select a location to place your radio-controlled clock where it will be at least six feet away from a TV, computer, air conditioner or other household electrical appliances. Windows facing Colorado provide the best signal. The WWVB time signal will easily penetrate masonry and wood framed buildings. WWVB will penetrate almost every residential building and most steel buildings if they have adequate windows. It is not possible, however, for WWVB to penetrate most indoor shopping malls and rooms in the center of large office buildings that do not have windows. In buildings that WWVB cannot penetrate, you may set the time using the manual time set button. When the clock receives the WWVB signal it will automatically set the hands to the exact time. 5 For more information on the NIST and radio controlled time, see www. boulder. nist. gov/timefreq/ *DST (Daylight saving time) ON/OFF button Pressing DST-ON/OFF button during DST the clock will switch to time without daylight saving. Pressing it again DST will be activated again. In areas where no DST is used you may deactivate DST by pressing the DST-OFF switch. SET THE TIME USING THE MANUAL TIME SET BUTTON In some cases, the clock may not receive the WWVB signal due to atmospheric disturbances or hard to reach locations such as inside shopping malls. In this case, please use the Manual Time Set button, located at the back of the clock to manually set the time. To do this: MANUAL TIME SET BUTTON 1. 4. Press and hold the Manual Set button. The second hand will move to the 12 position. Release the Manual Set button and again press and hold the Manual Set button. The minute and hour hands will fast-forward while the button is held. Keep holding the Manual Set button until the time is set as required. [. . . ] This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology, Ltd 2809 Losey Blvd. [. . . ]