User manual LA CROSS TECHNOLOGY WT-967S

[. . . ] The default (factory) setting is Daylight Saving Time On and 12-hour Time mode. Press and hold the TIME ZONE button for 4 seconds or until "DST ON" and "12h" are displayed in the LCD and then release the TIME ZONE button. "DST ON" and "12h" will flash in the time LCD. Press and release the TIME ZONE button to select the desired mode. [. . . ] While the watch is water resistant to 100 feet, do not submerge in water for extended periods of time. I. The default time zone is Eastern Time (EST, also GMT-5). The selection will cycle from GMT-5 (EST) to GMT-12, then GMT+12 to GMT +1, then GMT, then GMT-1 to GMT ­5 (EST). Hold down the TIME ZONE button for 2 seconds or until a time zone abbreviation and "ZONE" flash in the LCD and then release the TIME ZONE button. While the time zone abbreviation and "ZONE" flash in the LCD, repeatedly press and release the TIME ZONE button until the appropriate Time Zone is displayed. Wait 8 seconds for the automatic time-out to exit the time zone selection mode and the watch will return to the normal display. "Hawaii Time displayed (GMT-10) VI. REPLACING THE BATTERY The battery can either be replaced by a qualified jeweler or watch repair shop, or by the user. Any damage resulting from this procedure is not covered under warranty. Remove the four screws located on the back and remove the cover. Be sure the watch movement and gasket do not come out of the case. Remove the old battery by gently prying up the battery clip. Insert a new battery of the type "CR1620" 3 Volt Lithium Cell battery Please dispose of the old battery properly. 2. 3. 2. 3. Atlantic Time (ATL): Eastern Time (EST): Central Time (CST): Mountain Time (MST): Pacific Time (PST): GMT-4 GMT-5 GMT-6 GMT-7 GMT-8 Alaska Time (ALA): GMT-9 Hawaii Time (HAW): GMT-10 4. Battery compartment Battery clip Greenwich Mean Time (GMT): GMT TROUBLESHOOTING Problem: Solution: No WWVB signal (indicated by the absence of the WWVB tower icon). The WWVB signal will not be received because the watch is programmed not to search when outside of the range of the WWVB signal. Change the Time Zone to one of the time zone of the U. S and the watch will again search for the WWVB signal overnight. 2) Move watch 10 feet (3 meters) away from any interfering sources, i. e. electrical appliances (refrigerators, TV's, computers), metal surfaces or objects. 3) To help with overnight reception, place watch in a window with the band inline with the general direction of Ft. 4) There are a few places the signal is very weak (Los Angeles area, Some parts of Florida and New York City). Since the watch has a much smaller receiver than our other clocks, it is possible no reception can be made. Please inform La Crosse Technology in this case. The hour or minute is incorrect, even though the tower icon is on (indicating a successful reception of the WWVB time signal the previous night) and it is set to the proper time zone. 1) Electrical interference caused the time signal to be improperly received. [. . . ] This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. Problem: Solution: Note: For all questions not answered please contact La Crosse Technology (contact information is below). For warranty work, technical support, or information contact: La Crosse Technology 2809 Losey Blvd. La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 e-mail: support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com All rights reserved. [. . . ]