User manual LA CROSSE TECHNOLOGY 308A-805

[. . . ] A/C power adapter: Plug enclosed 6-volt a/c power adapter into a wall outlet, then into the weather station. 308A-805 Color Wireless Atomic Weather Station Introduction The Wireless Color Atomic Weather Station offers radio-controlled time, weather forecast, indoor and outdoor temperature/humidity and heat index with dew point, on one easy to read display. Forecast Icons Time Alarm Icon Function Buttons Batteries:  Remove battery: Slide tab to the left and pull out to remove battery cover.  Install three fresh AAA alkaline batteries according to the polarity markings.  Do Not Mix Old and New Batteries  Do Not Mix Alkaline, Standard, or Rechargeable Batteries If the weather station does not display indoor temperature after 60 seconds, remove adapter and batteries, and wait for at least 60 seconds before powering up the weather station again. INSTALL BATTERIES IN THE TRANSMITTER: Date display alternates with Heat Index and Dew Point display TX Button C/F Selection Channel Button   Battery Compartment Battery Cover  Remove screws and the battery cover from the back of the transmitter with a small screwdriver. [. . . ] Press and release the UP or DOWN button to select the Time Zone. North American Time Zones are:  -4 Atlantic  EST Eastern  CST Central  MST Mountain  PST Pacific  -9 Alaska  -10 Hawaii Press and release the SET button to continue. DST: DST will show, and On or Off will flash. Press and release the UP or DOWN button to select the On or Off. Press and release the SET button to continue. Press and release the UP or DOWN button to select the 12-hour or 24-hour time. Press and release the SET button to continue. Press and release the UP or DOWN button to select the Hour. Press and release the SET button to continue. Press and release the UP or DOWN button to select the Minutes. Press and release the SET button to continue. Press and release the UP or DOWN button to select the Year. Press and release the SET button to continue. Press and release the UP or DOWN button to select the Month. Press and release the SET button to continue. Press and release the UP or DOWN button to select the Date. Press and release the SET button to continue. WEATHER FORECAST ICON: Press and release the UP or DOWN button to select the forecast Icon that represents your current local weather. Press and release the SET button to exit. NOTE: If possible, it is best to select the RAINY ICON when it is raining outside. This allows for the most accurate future forecasts based on barometric pressure changes.          INDOOR: When Indoor Temperature/Humidity is displayed, press the HEAT/DEW button and Indoor Heat Index and Indoor Dew Point will show briefly in the date display area. OUTDOOR: When Outdoor Temperature/Humidity is displayed, press the HEAT/DEW button Outdoor Heat Index and Outdoor Dew Point will show briefly in the date display area. [. . . ] Place both units in their desired location, and wait approximately 10 minutes before permanently mounting the sensor to ensure that there is proper reception. The outdoor temperature sensor is not waterproof and should not be placed anywhere it will become submerged in water or subject to standing water or snow. SPECIFICATIONS: Indoor: Temperature Range: Humidity Range: Interval: Outdoor: Temperature Range: Humidity Range: Distance: Interval: Adapter: Receiver: Transmitter: Dimensions: Receiver: Transmitter: Contact Support: 1-608-782-1610 32° F to 122° F (0° C to + 50° C) 20%-99% (RH) Every 10 seconds Product Registration: www. lacrossetechnology. com/support/register -20°F to 140°F (-29°C to 60°C) 20%-99% (RH) 200 ft (60 meters) RF 434MHz (open air) Every 35 seconds This Device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) the device must accept any interference received, including interference that may cause undesired operation. [. . . ]