User manual LA CROSSE TECHNOLOGY BC1000 QUICK SETUP MANUAL

[. . . ] Within 8 seconds after inserting the batteries, select the charging current by pressing the CURRENT key. 200, 500, 700 or 1000 mA may be selected. (1500 & 1800 mA can only be selected if one or two batteries only are charged (bays 1 & 4 only)). After 8 seconds from the last key press, the display will blink once to indicate that the time allowed for setting is over and the charging will start. Charging current of 700 mA is selected. [. . . ] Now, batteries in compartment 1 and 2 are being charged. Insert the third battery for "Test" in compartment 3. Within 8 seconds from inserting the battery into compartment 3, press the corresponding compartment key "3". 3 display will flash after the compartment No. 3 is pressed 8. 9. 10. 11. Within 8 seconds from pressing the compartment key, press and hold the MODE key for 2 seconds then press and release the MODE key to select the "Test" mode for compartment 3. Note: Press the compartment key to select a particular compartment before pressing the MODE key, otherwise, the mode of all the compartments will be changed at the same time. Within the 8 seconds after the last key press, select the charging current in the test mode: 200, 500 or 700 mA Note: Although the individual bays are operated in different modes, the charging current of the second, third and fourth battery placed into the charger cannot be set higher than that of the first placed battery. 8 seconds after the last key press, the display will blink once to indicate that the time allowed for setting is over and the Test mode will start. Once charging has started, the current can no longer be changed. Now the batteries in compartments 1 and 2 are being charged, while the battery at compartment 3 is undergoing Test mode. Insert the fourth battery for "Refresh" into compartment 4. Within 8 seconds of placing a battery into compartment 4, press the corresponding compartment key "4". 4 display will flash after the compartment No. The battery will then catch the clip that is meant for the AAA batteries. If you do not get the AAA battery flat into the compartment, the battery will not catch the correct clip and will not charge. return shipping charges to the owner of the product to a USA address only. Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner's manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference. . This warranty covers only actual defects within the product itself, and does not cover the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance variations resulting from installation-related circumstances. LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ] Once charging has started, the current can no longer be changed. Now, batteries in compartment 1 and 2 are being charged, while batteries in compartment 3 and 4 are undergoing Test and Refresh mode respectively: During the operation, press and release the DISPLAY key, to view various display modes. (refer to figure below and Table 5 to 7 in the full manual). IMPORTANT NOTE USERS OF OUR BATTERY CHARGER BC-1000 ARE KINDLY REQUESTED TO CAREFULLY READ THE MAIN INSTRUCTIONS MANUAL BEFORE THE FIRST USE La Crosse Technology, Ltd 2817 Losey Blvd. South La Crosse, WI 54601 The complete instruction manual is available at: www. lacrossetechnology. com/support Le manuel d'instruction complet est disponible sur: www. lacrossetechnology. com/support El manual de instrucciones completo está disponible en: www. lacrossetechnology. com/support WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. [. . . ]