User manual LA CROSSE TECHNOLOGY TX6 INSTRUCTION MANUAL

[. . . ] Place the batteries into the outdoor remote first then into the indoor station. (All outdoor remotes must be started before the indoor station) DO NOT PRESS ANY BUTTONS FOR 10 MINUTES. In this time the display and sensor will start to talk to each other and the display will show both the indoor temperature and an outdoor temperature. If the station does not display both temperatures after the 10 minutes please retry the set up as stated above. [. . . ] The batteries will fit tightly (to avoid start-up problems make sure they do not spring free). Replace the battery cover by sliding upwards. Be sure battery cover is on securely. MOUNTING THE REMOTE TEMPERATURE SENSOR/TRANSMITTER The remote temperature sensor/transmitter can be mounted in two ways: · with the use of screws, or · using the adhesive tape. MOUNTING WITH SCREWS 1) Remove the mounting bracket from the remote temperature sensor/transmitter. 2) Place the mounting bracket over the desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. 3) Where marked, start the screw holes into mounting surface. 4) Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2) Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket. 3) Remove the protective strip from the other side of the tape. [. . . ] This warranty gives you specific legal rights. You may also have other rights specific to your state. Some states do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ]