User manual LA CROSSE TECHNOLOGY TX60U-IT-D

[. . . ] Note: The data is stored on the device every 6 seconds but is reported to the computer only at the intervals that you have selected in your online account (default is every 2 minutes). BEGIN SET UP First you must have a Weather Direct® Gateway registered so that it can communicate with your new TX60U-IT sensor. If you do not already have a Gateway registered, begin by registering your Weather Direct® Gateway online at: www. weatherdirect. com After successful online Weather Direct® Gateway registration, you will use to following steps to "connect" both devices: Step 1. Please make sure the TX60U-IT sensor is 3 to 10 feet away from the Gateway during the registration process. Registration may fail if the device is too close or too far from the Gateway. [. . . ] You must have an application on your computer that supports Microsoft® Excel formatted files for this option to work. Please refer to the documentation on www. weatherdirect. com for more information. 1 YEAR OF NOTIFICATIONS IS INCLUDED WITH INITIAL SENSOR ACTIVATION ON YOUR WWW. WEATHERDIRECT. COM ACCOUNT: Once the TX60U-IT sensor is set up on your www. weatherdirect. com account, you may choose to activate the optional cell phone / e-mail notifications: (1) If temperature or humidity exceed your defined range (2) If connection is lost (3) If batteries are low IMPORTANT NOTES ON SETUP & OPERATION The TX60U-IT sensor should be placed in a dry, shaded area. Please avoid a location with direct sun, as that will cause incorrect readings. Fog and mist will not harm the TX60U-IT sensor but direct rain must be avoided. Note: Exposing the TX60U-IT sensor case to extreme humidity may temporarily disrupt data. The sensor case reads humidity, but should not be `submerged' in water. The TX60U-IT sensor has a wireless range of 200 feet (60. 96 m). Keep in mind that the 200 ft range equates to open air with no obstructions, and that radio waves DO NOT curve around objects. Actual transmission range will vary depending on what is in the path of the signal. Each obstruction (roof, walls, floors, ceilings, thick trees, etc. ) will effectively cut signal range in half. BATTERY INSTALLATION 1. Remove the battery cover by sliding the cover down. Observing the correct polarity install 2 AAA, Alkaline batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free). Replace the battery cover by sliding upwards. Be sure battery cover is on securely. 3. whichever is longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will be charged for the repairs or examination. The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. La Crosse Technology, Ltd will pay ground return shipping charges to the owner of the product to a USA address only. Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner's manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference. . This warranty covers only actual defects within the product itself, and does not cover the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance variations resulting from installation-related circumstances. [. . . ] Do not submerge the sensor case in water. Avoid kinking the temperature probe cable. Immediately remove all low powered batteries to avoid leakage and damage. Opening the casings invalidates the warranty. [. . . ]