User manual LA CROSSE TECHNOLOGY WM5014

[. . . ] This is the reason for the new test function that allows the quality of reception to be checked in the surrounding area and to position the device in a location that has the best possible conditions. · Switch on all potential sources of interference (e. g. television) in the area that you want to install the station during the test!· Position the device in the location, oriented as you prefer, but at least one meter from the possible source of interference. [. . . ] Both fields for the following days (the far right on the display) remain empty. The data is synchronized again after changing the region. The reception of the new weather data requires at least 24 hours. Setting the time zone · From the start of the configuration, press the <SET> button again for the time zone setting mode. The text "ti" is shown on the display. The currently defined time zone is shown directly to the right. Use the <+> button to select the desired time zone. Note!The time received from the radio-time signal generator DCF or HBG is Central European Time (CET, CEST). Setting the time zone is therefore only required for other time zones (e. g. in Portugal or Great Britain). Contrast setting · · From the start of the configuration, press the <SET> button twice for the display contrast setting mode. The currently set value is displayed in the field on the right. The contrast can be set within a range from 1 to 16 using the <+> button. Pressing the <SET> button again ends configuration mode. Press the <+> button for at least 3 seconds to activate the test for the reception of weather data. The text "test" is shown on the display. The reception indicator for the weather data shows the quality of reception. The reception is good if the indicator is shown, otherwise a new location must be found for installing the weather station. The reception test is either ended after approx. 1 minute automatically or by actuating the <+> button. Reception test · · OPERATIONS Alarm function 9 · · · Press the <ALARM> button for at least three seconds to set the alarm time. The text "ALM" and the hours display flash. Use the <+> button for the hour setting. By pressing the <ALARM> button again, the minute setting is activated. Use the <+> button for the minutes setting. [. . . ] ±1° C Resolution: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0, 1° C Outdoor temperature: Range:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -39. 9 / +59. 9 ° C Accuracy:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±1° C Resolution: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]