User manual LA CROSSE TECHNOLOGY WS-8256-AL INSTRUCTION MANUAL

[. . . ] Your distance plus resistance should not exceed 80 ft. NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor temperature station after the 10 minutes have passed please follow the steps on pages 8-9. INVENTORY OF CONTENTS 1. The indoor temperature station (Figure 1) 2. [. . . ] Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-7034U. These extra remote temperature sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP will monitor the temperature of water or soil via a probe. When setting up multiple remote temperature sensors, it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensors. Second install batteries into the indoor temperature station and do not press any buttons for ten minutes. Transmission problems will arise if this is not done correctly. To view the temperature of a different remote temperature sensor unit, press and release the "SET/CH" button. A shift from one number to the next should be observed in the OUTDOOR LCD. MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on a North-facing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location before permanently mounting. Remove the mounting bracket from the remote temperature sensor. Mount the bracket in the desired location with either screws or adhesive tape. Reattach the remote temperature sensor into mounting bracket. Indoor Temperature Station The indoor temperature station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the indoor temperature station in an appropriate location. To wall mount the indoor temperature station first remove the table stand. Next insert an appropriate screw in your desired location. Using the integrated hanging hole on the back of the unit, slip indoor temperature station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature is displayed. Remove all batteries, reinsert into remote temperature sensor first, then into the indoor temperature station. Place remote temperature sensor closer to the indoor temperature station. Place remote temperature sensor and indoor temperature station in position so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. [. . . ] This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact La Crosse Technology 1116 South Oak Street La Crescent, MN 55947 Phone: 507. 895. 7095 Fax: 507. 895. 8000 e-mail support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) Website www. lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. [. . . ]