User manual LA CROSSE TECHNOLOGY WS-9133U-IT-CA

[. . . ] Instruction Manual and Warranty Card. Figure 1 Figure 2 ADDITIONAL EQUIPMENT (not included) 1. 2 Fresh AA 1. 5V batteries. 3 QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. Have the indoor temperature station and remote temperature sensor 3 to 5 feet apart. Batteries should be out of both units for 10 minutes. [. . . ] Press and release the "SET" button 2 times, the hour will flash in the upper left corner. Press and release the "MIN/MAX" button to set the hours 5. Press and release the "SET" button to move to the minute setting 6. Press and release the "MIN/MAX" button to set the minutes. Press and release the "SET" button to activate the clock. 11 Note: When in 12h mode, there is only a "PM" display, which appears under "TIME. " If there is no display here it is AM. Make sure you set the time accordingly. III. Press and hold the "SET" button for 5 second until "12h" or "24h" appears in the TIME LCD. Press and release the "SET" button again, "°F" will appear in the TIME LCD. Press and release the "MIN/MAX" button to shift between °F and °C. Press and release the "SET" button twice to activate settings. 12 IV. Press and release the "MIN/MAX" button, "MIN" appears in the temperature LCD's and the recorded minimum temperatures are displayed. Pressing and releasing the "MIN/MAX" button will toggle through the minimum and maximum indoor temperature, and the minimum and maximum outdoor temperature. To reset the Minimum/Maximum readings, press and hold the "MIN/MAX" button for four seconds. V. MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on an outside Northfacing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place 16 both units in their desired location before permanently mounting. A. Remove the mounting bracket from the remote temperature sensor 2. Mount using either screws or adhesive tape. Reattach the remote temperature sensor to the mounting bracket. B. The indoor temperature station comes with the table stand already mounted. If you wish to use the table-stand, all that is required is to place the indoor temperature station in an appropriate location. [. . . ] In addition, the much greater range of the outdoor temperature sensor requires a different calibration curve than the indoor range. Error is usually greater at the extreme 19 ends of a range, making it harder to compare different ranges with different curves. Under non-laboratory conditions, it is difficult to compensate for the above factors and obtain an accurate comparison. MAINTENANCE AND CARE INSTRUCTIONS · · Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. [. . . ]