User manual LA CROSSE TECHNOLOGY WS9723

[. . . ] Once the batteries are in place, all segments of the LCD will light up briefly. Following the time as 0:00 and the "weather girl" icon and indoor temperature and humidity will be 38 3. 4. 5. displayed. If these are not displayed after 60 seconds, remove the batteries and wait for at least 10 seconds before reinserting them. After inserting the batteries into the transmitter, the Temperature Station will start receiving data from the transmitter. [. . . ] · Within ferro-concrete rooms (basements, superstructures), the received signal is naturally weakened. In extreme cases, please place the unit close to a window and/or point its front or back towards the Frankfurt transmitter. MANUAL SETTINGS: The following manual settings can be done in the setting mode: · Time zone setting · Manual time setting · Calendar setting · °C/ °F setting Press and hold the SET key for about 3 seconds to advance to the setting mode: 47 TIME ZONE SETTING: flashing The time zone default of the Temperature Station is "0 hour". Press and hold the SET key for about 3 seconds to enter the time zone setting (flashing). The range runs between 12 to -12 hr, in consecutive 1hour intervals. Press the SET key to confirm and enter the "Manual Time Setting" or exit the setting mode by pressing the MIN/MAX key 48 MANUAL TIME SETTING In case the Temperature Station is not able to detect the Atomic time (DCF) signal (disturbances, transmitting distance, etc. ), the time can be manually set. The clock will then work as a normal Quartz clock. Hours (flashing) Minutes (flashing) To set the clock: 1. The hour digits start flashing in the time display section. Use the + key to adjust the hours and then press SET key to go to the minute setting. Confirm with the SET key and enter the "Calendar Setting" or exit the setting mode by pressing the MIN/MAX key Note: · The unit will still try to receive the signal at each full hour despite it being manually set. When it does receive the signal, it will change the manually set time into the received time. 49 · The time format is fixed to "24-hr" time display. CALENDAR SETTING Year "Date. Month" weekday The date default of the Temperature Station is 1. Once the radio-controlled time signals are received, the date is automatically updated. However, if the signals are not received, the date can also be set manually. The range runs from 2000 to 2029 (default is 2006). Press the SET key to enter the month setting mode. Press the + key to set the month and then press the SET key to go to the date setting. Confirm with the SET key and set the weekday. Press + key to select the weekday, "MO", TU", "WE" etc. Confirm with SET key and enter the "°C/°F TEMPERATURE UNIT SETTING" or exit the setting mode by pressing the MIN/MAX key. °C/°F TEMPERATURE UNIT SETTING flashing The default temperature reading is set to °C (Fahrenheit). The "°F/ °C" will be flashing, use the + key to toggle between "°F" and "°C". The alarm will then sound and the Ice Alarm icon will be blinking on the LCD. [. . . ] User shall take an active part in the reuse, recycling and recovery of the electrical and electronic waste. The unrestricted disposal of electronic waste may do harm on public health and the quality of environment. As stated on the gift box and labeled on the product, reading the "User manual" is highly recommended for the benefit of the user. This product must however not be thrown in general rubbish collection points. [. . . ]