User manual LA CROSSE TECHNOLOGY WT-2160 INSTRUCTION MANUAL

[. . . ] Take off the cover; you may need to pry it off using a paperclip or other small object. Remove the plastic from under the battery. Battery cover Battery Compartment B. Install the battery, type LR44, with the positive side facing out. The alarm will sound briefly after installation; do not press any buttons for 10 minutes. II. [. . . ] Press the "+" key to advance to the correct day of the week. i) "12" or "24" will now flash. Press the "+" key to select either 12 ­hour or 24-hour (military time). The programming is now complete. 4 2. PROGRAMMING SEQUENCE Time ZoneDST On/OFFSnooze SettingHourMinuteYearMonthDateDay12/24 hour format III. SETTING THE ALARMS La Crosse Technology's travel alarm clock has two separate alarms that can be set. Each alarm has a distinctive sound and operate independently. Press and hold the "ALM1" (or "ALM2" key) key for two seconds to enter the setting mode. Press the "HOUR" key to advance the hour of the alarm, and press the "MIN" key to advance the minutes of the alarm. If no button is pressed within fifteen seconds, the alarm will set and will activate, and the clock will revert to the normal operating screen. The picture below shows both alarms activated. B. To activate/deactivate the alarm, press the "ALM1" or "ALM2" key once, depending on which alarm needs to be activated. "Alarm 1" activated "Alarm 2" activated C. When the alarm is sounding, pressing the "SNOOZE" bar will turn it off for the time that was selected in the programming mode (section II. A. 2. c. ). If the setting is "0", the alarm will turn off for 24 hours. During the snooze period, the lower screen will show a countdown until the alarm will sound again. If the snooze bar is pressed again during the original snooze period, the period will be reset. Once the period is finished, the alarm will sound again. Pressing any key other than the snooze key will turn off the alarm for 24 hours. IV. The exact time will always be displayed in the upper portion of the screen, and the US map will show when the time zone is set to the continental US (with the time zone selected showing in black). The lower portion of the screen has five different screens that can be selected. The default is "DAY, MONTH, DATE" as shown below. Press the "MODE" key to select which screen to show. [. . . ] For warranty work, technical support, or information contact La Crosse Technology 1116 South Oak Street La Crescent, MN 55947 Phone: 507. 895. 7095 Fax: 507. 895. 8000 e-mail support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) Website www. lacrossetechnology. com THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. [. . . ]