User manual LA CROSSE TECHNOLOGY WT-2165 INSTRUCTION MANUAL

[. . . ] The WWVB tower icon (appearing in the TIME LCD) will flash when a signal-search is in progress and a signal is being received, and will remain steady when the signal has been received. If the WWVB time has not been received after 10 minutes of battery installation, you may manually set the time or wait for the WWVB reception. About Radio-Controlled Time signal, WWVB: The NIST (National Institute of Standards and Technology--Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time and date signal continuously throughout the United States at 60 kHz. The signal can be received up to 2, 000 miles away through the internal antenna in the alarm clock. [. . . ] x) Press and release the "SET" key. y) The day of the week will now flash (Sun, Mon, etc. ). 4 z) Press and release the "+" key to advance to the correct day of the week. aa) Press and release the "SET" key. bb) "12" or "24" will now flash. cc) Press and release the "+" key to select either 12 ­hour or 24-hour (military time). dd) Press and release the "SET" key to complete the programming. The programming is now complete. D. SETTING THE ALARMS La Crosse Technology's travel alarm clock has two separate alarms that can be set. Each alarm has a distinctive sound and operates independently. a) Press and hold the "ALM1" (or "ALM2" key) key for two seconds to enter the setting mode. c) Press and release the "HOUR" key to advance the hour of the alarm, and press and release the "MIN" key to advance the minutes of the alarm. Note: If no button is pressed within fifteen seconds, the alarm will set and activate, and the clock will revert to the normal operating screen. The picture below shows both alarms activated. "Alarm 1" activated "Alarm 2" activated Activating the Alarms To activate/deactivate the alarm, press and release the "ALM1" or "ALM2" key once, depending on which alarm needs to be activated. Activating the SNOOZE function When the alarm is sounding, pressing the top of the unit gently backwards will activate the snooze for the time that was selected in the programming mode. If the setting is "0", the alarm will turn off for 24 hours. During the snooze period, the lower screen will show a countdown until the alarm will sound again. If the snooze is activated again during the original snooze period, the period will be reset. Once the period is finished, the alarm will sound again. Pressing any key other than the snooze will turn off the alarm for 24 hours. III. The exact time will always be displayed in the upper portion of the screen, and the US map will show when the time zone is set to the continental US (with the time zone 5 selected showing in black). The lower portion of the screen has five different screens that can be selected. The default is "DAY, MONTH, DATE" as shown below. Press and release the "MODE" key to select which screen to show. [. . . ] For warranty work, technical support, or information contact La Crosse Technology 1116 South Oak Street La Crescent, MN 55947 Phone: 507. 895. 7095 Fax: 507. 895. 8000 e-mail support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) Website www. lacrossetechnology. com THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. [. . . ]