User manual LA CROSSE TECHNOLOGY WT-2192

[. . . ] Next insert one AA alkaline battery into the battery compartment making sure to observe the correct polarity. When inserting the battery be sure not to press any of the buttons on the travel alarm as this will interrupt the WWVB search and may cause the travel alarm to not pick up the radio-controlled time signal. Now replace the battery cover and face the travel alarm with the back of the unit towards Colorado (this has been found to help the unit pick up the WWVB signal). When the WWVB signal is received a tower icon will appear on the left side of the LCD display. NOTE: Due to the nature of the WWVB signal it may take overnight for the travel alarm to receive the signal and set. [. . . ] The time zone abbreviation will appear in the LCD. "DST" will be displayed to the left of the time zone abbreviation. Press and release the "MODE/MIN" button to toggle between daylight saving time on and off. Press and release the "Snooze" button twice to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Display Mode Setting The display below the time can be switched between showing the seconds and the alarm time. To switch between these two modes press and release the "MODE/MIN" button. Setting the Alarm To set the alarm press and hold the "AL/HR" button for three seconds. · · · · The alarm time will flash in the bottom left of the LCD screen. Press and release the "AL/HR" button to advance to the desired hour. Press and release the "MODE/MIN" button to advance to the desired minute. Press and release the "Snooze" button to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Operating the Alarm and Snooze To turn the alarm on press and release the "AL/HR" button. The alarm icon will be displayed in the lower right of the LCD to indicate that the alarm has been turned on. 4 The alarm will sound for 100 seconds once activated. By pressing the snooze button the alarm will be suspended for 8 minutes. Operation of the snooze function can be done in two ways: · Press and release the "SNOOZE" button on the front of the travel alarm. · With the travel alarm resting open on a flat surface, by gently pushing back on the top of the alarm. NOTE: This movement causes the opened lid to activate a second snooze button which is located on the bottom of the travel alarm (it can be seen just below the battery compartment). TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The time and date will not set initially. Solution: It usually takes overnight before the clock can receive the signal due to the interference the sun has on the WWVB signal. Solution: Computer monitors and televisions can cause interference with the signal reception. Please keep the clock at least six feet from electrical sources. Solution: In some areas of the US, in particular on the East and West coasts, the signal is very weak. It may take up to 72 hours before a good signal is received. The reception can be helped by placing the clock in a window facing Colorado, with the back towards Colorado. [. . . ] For warranty work, technical support, or information contact La Crosse Technology 1116 South Oak Street La Crescent, MN 55947 Phone: 507. 895. 7095 Fax: 507. 895. 8000 e-mail support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) Website www. lacrossetechnology. com THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. [. . . ]