User manual LA GERMANIA LUGF03-60-S

[. . . ] LUGF03-60-S MODEL LUGF03-60-S UPRIGHT COOKER Installation instructions Part no: W2005 Revision E - 2008 User instructions This cooker is approved for use with Natural and Propane gases Leave instructions with the owner 32 Contents Contents Important information Introducing your new cooker Notes on disposal Before connecting your new cooker Safety considerations 2-3 4-5 Installation instructions Statutory regulations Gas supply Electrical supply Instructions Vertical clearances Overhead clearances Side clearances to vertical surface Installation 6-7 Electrical & gas connection Electrical connection Gas regulator If using a flexible connection If using a copper connection Gas connection Gas inlet position - Nat Gas & LPG Gas inlet with different leg heights - mm Energy consumption Test the operation of the cooker before leaving Warrant warning For service to this appliance 8-9 Support legs Anti-tilt restraint Upstand installation Cooktop operation Control panel layout Minute minder First time use Cooktop burners operation Cooktop burner adjustments Ventilation Use of cooktop burners 10 11 12 13-14 2 31 Data plate - Nat Gas Oven/Grill operation Accessories First time use Shelf positions Thermostat operation Cooling fan operation Temperature settings Automatic ignition Manual ignition Cooking tips 15-17 Data plate - LP Gas Cooking chart Trouble shooting guide Cleaning Cleaning cooktop Cleaning oven interior Cleaning oven shelf supports Cleaning oven glass door Replacing the oven light 18-19 20-21 22-23 Service information 24-30 To remove glass lid (for cookers fitted with glass lid) To remove upstand (for cookers fitted with an upstand) Access to under hob area To replace the gas control valves or gas manifold To replace the minute minder To replace the thermostat To remove side panels To remve oven door To replace oven thermocouple To replace electronic ignition box To replace the oven electronic ignition module To clean or replace the oven burner injector To clean or replace a cooktop burner injector To replace a cooktop burner electronic spark electrode To replace the oven door inner glass panel To replace the oven door outer glass panel To replace the oven door hinges To replace the fan motor Wiring diagrams Data plates (Nat Gas & LP Gas) 30 3 Important information We thank you and congratulate you on your choice. This carefully designed product, manufactured with the highest quality materials, has been carefully tested to satisfy all your cooking demands. We therefore request that you read and follow these easy instructions which will allow you to obtain excellent results right from the start. The cooker is supplied with a stainless steel upstand. [. . . ] To remove upstand (for cookers fitted with upstand) 1. To remove the upstand retaining brackets undo the 2 top and 2 rear retaining screws securing each bracket. Remove the glass lid/upstand brackets as per heading `To remove upstand. Remove pan supports, burner caps and burner heads. Using a torx T20 head driver remove the screws securing the burners to the hob. 2 per boiling burner and 4 for the wok burner. Lift hob at rear and slide out of position. Ensure that the hob engages the securing slot at the front. To replace the gas control valves or gas manifold Pull cooker forwards to gain access to the rear of the cooker and follow procedure above to gain access to under hob area. Remove the control facia panel, by using a phillips head screwdriver to remove 2 screws either side from inside the under hob area. Disconnect all burner supply pipes at manifold. Disconnect spark ignition modules from gas valves. Undo flame failure device from gas valves. The whole burner support assembly can now be pulled towards the rear, to service the gas manifold. To replace a valve unscrew gas valve from manifold. Ensure gas tightness to gas manifold assembly. Test the operation of the cooker before leaving Note: these burners have no aeration adjustment. Check correct operation of the ignition system and operation of burners individually and in combination. Burner flames should be clear blue, with no yellow tipping. If the burners show any abnormality check that the burner heads are correctly located. If satisfactory performance cannot be obtained, contact Sampford & Staff or the local gas utility. Important Before leaving instruct the owner in the use of the cooker. Warranty warning It should be expressly noted that we cannot accept any liability for direct or indirect damage caused by wrong connection or improper installation. When being repaired, the appliance must always be disconnected from the mains supply; if required, notify our customer service. For service to this appliance This appliance is imported For service to this appliance please contact and distributed by: SampfordIXL P/L 52 - 70 Sparks Avenue Fairfield, Vic, 3078 Phone: Phone: 1300 727 421 Fax: 1300 727 425 Email service@sampfordixl. com. au 24 9 Support legs The cooker is fitted with four transit supports. [. . . ] Turn fan on again once cooking has resumed. Open door as little as possible during operation. If it is necessary to cover food with foil or baking paper whilst cooking in fan mode, ensure that the foil or paper is firmly secured. Avoid using dark scone trays, cake tins or muffin trays. [. . . ]