User manual LA SOMMELIERE CONTEMPRO180

[. . . ] As the appliance contains a flammable refrigerant, it is essential to ensure that the refrigerant pipes are not damaged. Standard EN378 specifies that the room in which you install your appliance must have a volume of 1m³ per 8 g of hydrocarbon refrigerant used in the appliances. This is to avoid the formation of flammable gas/ air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of the refrigerant used in your appliance is indicated on the rating plate. [. . . ] The child lock device is cancelled by pushing the “up and down” buttons simultaneously. 3 seconds “Pon” flashes in the display, and the temperature can be set. Temperature setting at the top of the appliance Temperature indication The display shows the actual temperature. The upper digits of the display indicate the temperature at the top of the appliance, and the lower digits of the display indicate the temperature at the bottom of the appliance. The temperature indicator is equipped with a built-in filter which simulates the actual temperature in the bottles. Consequently, the indicator does not react on short-term fluctuations of the air temperature Push SET1. Then the temperature at the top of the appliance can be adjusted up and down by means of the “up and down” buttons. The temperature can be adjusted from 8 to 22°C, however so that the temperature cannot be set at a lower temperature than the actual set point for the bottom temperature sensor. Temperature setting at the bottom of the appliance Push SET2. Then the temperature at the bottom of the appliance can be adjusted up and down by means of the “up and down” buttons. The temperature can be adjusted from 5 to 22°C, however so that the temperature cannot be set at a higher tempera- 8 GB ture than the actual set point for the upper temperature sensor. Two-zone setting for serving temperature Alarm devices There is a sub-alarm for the low-temperature sensor and an excess-alarm for the high-temperature sensor. The alarm consists of a beeper and a warning on the display. Alarm for high temperature: beep sound + alternating display of “Hi” and actual temperature Alarm for low temperature: beep sound + alternating display of “Lo” and actual temperature The alarm temperature depends on the set points. However, at position 5 of the subalarm is always 3 degrees. It is activated if the temperature has been below 3°C for 10 minutes. The beep sound can be cancelled by pushing a random thermostat button. Push the on/off button to erase the display alarm, first for cancelling the alarm, then again for restarting the compressor. Typical serving temperature settings for the top and bottom sections are 16°C and 6°C respectively. With these settings, a suitable temperature gradient will be achieved in the cabinet for the storage of various types of wine distributed from top to bottom as follows: ●● heavy red wines +16 to +19°C ●● rosé and light red wines +12 to +16°C ●● white wines +10 to +12°C ●● champagne and sparkling wines +6 to +8°C It is recommended that wine be served at a temperature which is a couple of degrees lower than the desired drinking temperature as the wine will be warmed slightly when it is poured into the glass. Single-zone setting for longterm storage Light For long-term wine storage, the top and bottom sections should both be set at 12°C. With identical settings for the top and bottom sections, the controls will maintain an even temperature throughout the cabinet. [. . . ] Repairs performed by others than approved service centres and any other faults and damage that the manufacturer can substantiate are caused by reasons other than manufacturing or material faults are not covered by the warranty. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union. If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [. . . ]