User manual LA SOMMELIERE CTV250

[. . . ] 2 Installing the drip tray Install the drip tray on the compressor support at the back of the cabinet, locating it under the small pipe protruding from the housing, the lower part of the tank being placed under this pipe. See diagram below: Installing the drip tray 3. 3 Installing the carbon filter Install the carbon filter, which you will find inside your cabinets, by placing it in the air circulation hole located on the top inside the cabinet. The carbon filter can be used for one year, please change it thereafter. [. . . ] The two shelf bracings should be at the same level to keep the shelf stay at a perfect position. Two dumpy wires in front of the shelf should lock the shelf on the shelf bracing 3. 3 Installing the wooden shelf See diagram below to install your wooden shelf. Put the shelf on the shelf bracing with the front going first. Make sure the wooden pin should be after the back shelf bracing hook. 7 The installation of door base support When replacing the reversible door, should change the installation direction of the base support; rotating pull up at the same time the base support can be removed; spin down at the same time the base support can be fixed. 8 The installation of the wall separate screws When the back side of wine cellar placed against the wall, should need to install the wall separate screws. As shown, the wall separate screws were installed in the flange on both sides of compressors pallet. 2 Temperature settings (1)Press , the display start to flash, then press or to adjust temperature. Press and hold down for 5 seconds to display the life of carbon filter (unit: day). Otherwise the display automatically returns to the temperature display after 15 seconds. note: Don’t press (3)The button two LED mode: “ ”. Press when displaying the life of carbon filter, or the number of life will be disordered. Press and hold down for 5 seconds to display the ” When door opens, displaying symbol when confirm. ϼ5） press and together at sametime, humidity values will be displayed on the display panel, after 5 for 5 seconds, all output will be cut off including the display and LED. Gently press seconds, the display should be returned to the original layout automatically. 3 Alarm explanation “Door open” alarm: will flash when door is open for more then 15 minutes and your will hear the buzzer ring three times every 30 seconds. Change the carbon filter and press when pressing . Will flash and the buzzer will for 5 seconds, then the life of new carbon filter will display 4. 4 Humidity alarm display When the relative humidity values less than 50% more than 72hours, the display symol “ flashes. The symol should lifting flash until the humidity is greater than 50%. 5 Operating faults Temperature: will flash when the temperature excess the limit between -300C and 600C. [. . . ] They could damage the wine cabinet and cause themselves serious injury. (10) Take care to keep keys out of reach of children in order to avoid them locking themselves in the cabinet. (11)Do not try to repair any damaged wire or electric components. Simple problem analyses Problem Compressor not working Problem analyses Power not connected Power lead or wire damaged Fuse broken Internal circuit fault Power supply off In heating process Resolve method Check the power Contact distributor or service agent Change fuse Contact distributor or service agent Check if power cut Common phenomena. [. . . ]