User manual LA SOMMELIERE CTV60.2Z

[. . . ] 3 Installing the carbon filter Install the carbon filter, which you will find inside your cabinets “accessories” box, by placing it in the air circulation hole located on the top inside the cabinet. The carbon filter can be used for one year, please change it thereafter. Contact your local distributor for new carbon filter. Please remove the used carbon filter before inserting the new one. [. . . ] Put the shelf on the shelf bracing with the front going first. Make sure the wooden pin should be after the back shelf bracing hook. 7 The installation of door base support When replacing the reversible door, should change the installation direction of the base support; rotating pull up at the same time the base support can be removed; spin down at the same time the base support can be fixed. 8 The installation of the wall separate screws When the back side of wine cellar placed against the wall, should need to install the wall separate screws. As shown, the wall separate screws were installed in the flange on both sides of compressors pallet. 2 Temperature settings (1) Upon temperature zone on the display broad with the symbol " on the display broad with the symbol " (2) Press " indicates. Press or to adjust " indicates, under temperature zone , the display start to flash, then press again that the display (flashing) display other zone set temperature, then press temperature of another zone. 8 seconds if no operation, display board will display real-time temperature. (3)The button is disabled without pressing . Press and hold down for 5 seconds to display the life of carbon filter (unit: day). Otherwise the display automatically returns to the temperature display after 15 seconds. Note: Don’t press (4)The button when displaying the life of carbon filter, or the number of life will be disordered. Press and hold down for 5 seconds to display the ” ②When door opens, displaying symbol when confirm. otherwise the display two LED mode: ①Stay on mode , displaying symbol “ ”. Press to choose LED mode, then press “ automatically returns to the temperature display after 15 seconds. ϼ5）Press and hold for 5 seconds, all output will be cut off including the display and LED. gently press 22 to restore all output. ϼ6） press and together at sametime, humidity values will be displayed on the display panel, after 5 seconds, the display should be returned to the original layout automatically. 3 Alarm explanation “Door open” alarm: will flash when door is open for more then 15 minutes and your will hear the buzzer ring three times every 30 seconds. Change the carbon filter and press when pressing . Will flash and the buzzer will for 5 seconds, then the life of new carbon filter will display 4. 4 Humidity alarm display When the relative humidity values less than 50% more than 72hours, the display symol “ flashes. [. . . ] (19) Do not keep the door open any longer than necessary. (20) Do not allow children to climb, sit on, stand on or hang from the shelves of the wine cabinet. They could damage the wine cabinet and cause themselves serious injury. (21) Take care to keep keys out of reach of children in order to avoid them locking themselves in the cabinet. [. . . ]