User manual LA SOMMELIERE CVD102DZ

[. . . ] Com 17 Before use, please read and follow the safety rules and operating instructions in this manual. Firstly, we would like to thank you for choosing our products and hope that this appliance will fully live up to your expectations. This appliance enables you to store your bottles or bring them to service temperature (depending on the bottles) thanks to its wide adjustment range. GENERAL SAFETY INSTRUCTIONS For your own safety and for the proper utilization of the appliance, read this manual carefully, including the warnings and recommendations, before installing the appliance and using it for the first time. [. . . ] Caution: Do not store explosive substances, such as aerosol cans containing an inflammable propellant, in the appliance. Caution: Do not damage the refrigerating circuit in the appliance. Caution: The refrigerating units use isobutane (R600a), and should not be placed close to ignition sources (for example, electrical contacts that are exposed or open contacts that could be closed by the refrigerating fluid in the event of a leak). The refrigerating fluid type is specified on the power cabinet identification plate. Caution: Do not use electrical equipment in the compartments of the appliance, unless they are of the type recommended by the manufacturer. TECHNICAL DATA Below is an example of the nameplate: The nameplate attached to the inside or rear of the appliance (depending on the model) includes the entire information specific to your appliance. We recommend that you make a note of its serial number in this booklet prior to installation, so that you can refer to it later (technical work, request for assistance, etc. Once the appliance is installed and loaded, access to it is not so easy. CAUTION: no assistance can be provided without this information. DESCRIPTION OF THE APPLIANCE ① ② ③ ④ ⑤ ⑥ ⑦ ⑧ ⑨ ⑩ 11 Front hinge LED light Fan base Cabinet Shelf Adjustable feet Door Door glass Handle Lower hinge Control panel 24 4. INSTALLATION INSTRUCTIONS Before using this appliance ▪ ▪ Remove the exterior and interior packing. Before connecting the appliance to the power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. –ª ▪ ▪ ▪ ▪ ▪ Clean the interior surface with lukewarm water using a soft cloth. When disposing your appliance, please choose an authorized disposal site. Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level your Wine cooler, adjust the front leveling leg at the bottom of the wine cooler. Adequate ventilation is required, do not block the front air outlet. This wine cellar is designed for free-standing Connect the cellar to a single socket, leaving a 30-mm gap between the back of the cellar and the wall. Be careful to support it, so that your wine cellar is perfectly level (use of a spirit level is recommended). This will prevent any movement due to instability, causing noise and vibration, and will ensure that the door seals perfectly. –ª ▪ This appliance is intended to be used exclusively for the storage of wine. [. . . ] PROBLEM Appliance is not running POSSIBLE CAUSES Appliance is not plugged in Appliance is not turned on Check if voltage of the installation Check the circuit breaker or if fuse has blown Check the temperature control setting Check if ambient temperature is beyond appliance operating temperature The door is opened too frequently The door is not closed properly The door is not sealing properly Insufficient free space around the appliance The external temperature is high. A large quantity of bottles has been put into the cellar. The appliance is opened The door is not properly closed. The appliance is not plugged in The fuse has blown LED lights are not broken The light switch is off Check and ensure that the appliance is level A noise resembling circulating water is produced by the coolant gas and this is normal. [. . . ]