User manual LA SOMMELIERE CVDE46

[. . . ] Junked or abandoned appliances are still dangerous . Even if they will “just sit in the garage a few days”. Before you throw away your old Wine Cooler: Take off the door. Leave the shelves in place so that children may not easily climb inside. [. . . ] Make sure to put the adjusting washers at the designated position. Locate the glass door to the designated position making sure that the door shaft enters the door hole at the left upper corner of the glass door. Install the two screws that are used to connect the left lower hinge with the glass door and tighten them before the door is leveled. Then remove the handle from the left side and install it on the right side of the door. 13 OPERATING YOUR WINE COOLER These Wine Cooler should be placed in where the ambient temperature is between 5-35℃. If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The controls of your Wine Cooler • • • • • Indicator light illuminates to signify the cooling mode is currently in operation. € ” Button To control this appliance turn on/off ( press and hold this buttons for approximately 2 seconds). Setting the Temperature Control The Wine Cooler has two temperature zones. “ ” Button Used to set temperature in lower zone. When you push the two buttons for the first time, the LED readout will show the previously set temperature set for that zones . € The temperature preset at the factory are: Upper zone:: 6 Lower zone: 12 • To set the temperature in the Upper zone press Set Upper button once. The temperature will decrease by every time the button is pressed until minimum temperature is reached, at which point it will then revert back to its maximum setting and start again. € To set the temperature in the Lower zone press the Set Lower button and follow the instructions above. € To view the temperature set in either zone at any time, press the corresponding “Set Upper” or “Set Lower” button, the “Set” temperature will temporarily flash in the LED display for 5 seconds. NOTE: 14 • If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will not start. € When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the Wine Cooler is running for a few hours everything will be back to normal. € • • • How to remove the Shelves To prevent damaging the door seal, ensure that the door is fully opened before pulling the shelves out. [. . . ] The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your Wine Cooler. Contraction and expansion of the inside walls may cause popping and crackling noises. The door was reversed and not properly installed. [. . . ]