User manual LA SOMMELIERE TR2V120

[. . . ] Even if they will “just sit in the garage a few days”. Before you throw away your old Wine cooler: Take off the door. Leave the shelves in place so that children may not easily climb inside. Never allow children to operate, play with, or crawl inside the appliance. [. . . ] Setting the Temperature Control The Wine Cooler has two temperature zones. “ ” Button Used to set temperature in lower zone. When you push the two buttons for the first time, the LED readout will show the previously set temperature set for that zones . € The temperature preset at the factory are: Upper zone:: 6 Lower zone: 12 • To set the temperature in the Upper zone press Set Upper button once. The temperature will decrease by every time the button is pressed until minimum temperature is reached, at which point it will then revert back to its maximum setting and start again. € To set the temperature in the Lower zone press the Set Lower button and follow the instructions above. € To view the temperature set in either zone at any time, press the corresponding “Set Upper” or “Set Lower” button, the “Set” temperature will temporarily flash in the LED display for 5 seconds. 12 NOTE: • If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine cooler will not start. € When you use the Wine cooler for the first time or restart the Wine cooler after having been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the Wine cooler is running for a few hours everything will be back to normal. Door Lock Your unit is provided with a lock and key combination. The keys are located inside the plastic bag that contains the User’s Guide. Insert the key into the lock and turn it counterclockwise to unlock the door. To lock the door do the reverse operation making sure metal pin is engaged completely. Remove the key and place it in a secure place for safekeeping. Interior Light You can turn the interior light ON or OFF by pushing the button marked with the “bulb” symbol . CARE AND MAINTENANCE Replacing Your LED Light NOTE: You must cut off electrical power avoid tip-and-run hurt. Please remove 2 fixed screws of the top shelf by Philips screwdriver and take out the shelf. (Attention please: LED light is covered by electrical box. ) Please take out lock screw 2 by Philips screwdriver first, then push the light cover to left, you can take out it when light cover set out limited location. [. . . ] The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your Wine cooler. Contraction and expansion of the inside walls may cause popping and crackling noises. The door was reversed and not properly installed. [. . . ]