User manual LAGRANGE 489001

[. . . ] F  or your safety, it is recommended never to use or leave the appliance in an area exposed to bad weather and humidity. D  o not leave the appliance connected without using it. D  o not move the appliance when it is operating. T  hese appliances are not designed to be operated using an external timer or by a separate remote control system. [. . . ] Using the measuring jug, fill the tank without exceeding the maximum level indicated by the arrows and the “FULL” marking. Step 3: Programming Connect the appliance correctly to the mains. Select the size of ice-cubes  (small, medium or large) by successively pressing the SELECTION button. Press the START button to start the production of ice cubes. 42 Step 4: Removing the ice-cubes After about 1h30 of production, the tray is filled with ice-cubes. The “tray full” indicator lamp then turns red and the appliance stops the production. The ice-cubes are kept cool in the appliance but will nevertheless start melting. Therefore, empty the ice-tray quickly, either to use the ice-cubes immediately, or to refrigerate them in the freezer before the next use. Step 5: Continuing production If you wish to have a larger quantity of ice-cubes, and therefore continue the production of ice cubes, re-insert the empty tray. The “tray full” indicator lamp goes off and the production restarts. Step 6: Depletion of water in the tank After about 2h to 2h 30 of use (depending on the ice cube size selected), the appliance would have exhausted the water in the tank. The “lack of water” indicator lamp turns red as there is no longer sufficient water to restart a cycle. If you wish to have a larger quantity of ice-cubes, and therefore continue the production of ice cubes, remove the tray and fill the tank with water without exceeding the maximum level. The “lack of water” indicator lamp goes off and the production restarts. Step 7: Stopping production When the quantity of ice-cubes obtained is sufficient, the production may be stopped by pressing the STOP button. Remove the ice-tray to collect the last ice-cubes produced. Step 8: Draining the appliance If there is any water left in the appliance once the production is over, it may be drained. To do this, move the appliance closer to the edge of the table. Turn it around so that it stands on three legs and the drainage button is accessible. Remove the plug then place a container under the plug. Remove the small white seal to enable the water to flow. When the water stops flowing, replace the seal, then the plug and push the appliance back on the counter before putting it away. [. . . ] P  ut away the appliance on a flat and easily accessible surface. D  o not put anything on top of the appliance. guarantee conditions_____________________ Your appliance is guaranteed for 2 years. To enjoy an additional year of guarantee free of cost, register on the website (www. [. . . ]