User manual LARSON CLASSIC ELEGANCESEAL

[. . . ] 202220564 LM 4/04 Classic-Seal/Classic-Elegance Storm Doors INSTALLATION INSTRUCTIONS Congratulations on your new storm door. Your satisfaction is Larson's number one priority. If you need assistance or parts, please call our hotline or visit our website. READ BEFORE BEGINNING INSTALLATION TOP Z-BAR OR DRIP CAP CAUTION INSTALLATION QUESTIONS? [. . . ] Proof of purchase required. 6 CS/CE OVERLAP 202220564 Classic-Seal/Classic-Elegance Storm Doors CLOSER INSTRUCTIONS Closer Installation (Some models have two closers and others have one closer. ) 1. Slide hold-open washer onto closer rod as shown. Pull rod out of closer so that there is a approximately 1/4" gap per Figure 1 (insert small screwdriver in rod hole to provide pulling grip). Closer Assembly Position washer behind flanges and against the closer. This will give proper tension for installation. (Do not change until installation is complete. ) See Figure 1. Attach brackets to closer as shown in Figure 2. Attach front Be sure door opens hole in closer to door bracket (long connecting pin). Attach and closes freely closer rod to side jamb bracket (short connecting pin) with before installing the open side of jamb bracket toward storm door (see arrow on closer. Your closer assembly is now ready to be attached to inside of door. Close and latch door. STEP 1 1/4" "HOLD OPEN" WASHER CLOSER FLANGE EXTEND ROD 1/4" OUT FIGURE 1 CLOSER INSTALLATION 1/4" FROM DOOR 1. To install the closer, hold closer assembly 1-1/2" above door window and hold jamb bracket 1/4" back from storm door. Closer Assembly Mark jamb bracket holes and two holes in door bracket. Fasten jamb bracket to jamb with four #10x1-1/2" screws. The open side of the jamb bracket should be toward the storm door (see arrow on bracket). Hold the closer and door bracket level and mark the location for the insertion of the door bracket screws. CAUTION: Do not drill through the outside of door. Install two #10 x 5/8" screws in bracket. To hold the door open: open door and slide hold-open washer over flanges toward cylinder on closer. STEP 2A ONE-CLOSER MODELS DOOR BRACKET T O OP CH PIN OO FD R HINGE SIDE JAMB #10 x 1-1/2" SCREWS 1-1 /2" TOP CLOSER #10 x 5/8" SCREWS SHORT CONNECTING PIN LONG CONNECTING PIN SIDE JAMB BRACKET BOTTOM CLOSER /2" 1-1 PIN CH LOOKING AT DOOR FROM INSIDE 1. To install the top closer, hold closer assembly 1-1/2" above door window and hold jamb bracket 1/4" back from storm door. Closer Assembly Mark jamb bracket holes and two holes in door bracket. Fasten jamb bracket to jamb with four #10x1-1/2" screws. [. . . ] Lubricate with 3-in-1 oil, cooking oil, or a silicone spray lubricant. Chisel wood out from under individual hinge. Call 1-888-483-3768 With retainer strips removed, center glass or screen assembly in the opening. To install the retainers, start one end of the retainer into the track at the top or bottom of window and push retainer into track. [. . . ]