User manual LARSON CLASSIC-VIEW

[. . . ] CLASSIC-VIEWTM Storm/Screen Doors INSTALLATION INSTRUCTIONS Before You Get Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 2 Installation Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pages 2­9 Warranties . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 7 Closer Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pages 8-9 General Care and Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 10 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 11 Visit our web site at www. larsondoors. com NOTE: Larger parts may need to be ordered at the store. Congratulations!You've purchased a quality-built storm/screen door from Larson. Please take a moment to fill out and mail in your product warranty card for years of trouble-free service. Larson offers you one of the most liberal warranties in the industry (see page 6 for warranty information). [. . . ] Attach the latch and hinge z-bar screw covers as described in step #1. FIGURE 23 TOP Z-BAR (DRIP CAP) SCREW COVER VINYL SCREW COVER HINGE Z-BAR SHOWN HINGE Z-BAR *NOTE: Some models do NOT come with screw covers! DETAIL A INSTALLED POSITION LATCH Z-BAR FIGURE 24 TOP Z-BAR (DRIP CAP) SCREW COVER HINGE Z-BAR SHOWN PUSH ON VINYL SCREW COVER HINGE Z-BAR LATCH Z-BAR INSTALLED POSITION Larson Storm Door Warranties CLASSIC-VIEWTM Limited Lifetime Warranty During life of door, new door at no charge. Hardware warranty is 1 year, covering workmanship and mechanical parts (brass finish is not covered under the warranty). Brass is like fine silver, it needs occasional maintenance. To maintain your brass finish, see the "General Care and Maintenance" section on page 10. HARDWARE 1-Year Warranty STORM DOOR WARRANTY LIMITATIONS: Modification of door will void warranty. Screen damage, glass breakage, or wind damage is not covered under warranty. In order to obtain performance under these warranties, the original owner shall do the following: 1. Send in the warranty registration card within 30 days following purchase. Notify authorized dealer of defect, with proof of purchase. 202220565 CLASSIC-VIEW SERIES 7 Classic-ViewTM Series Storm/Screen Doors CLOSER INSTRUCTIONS 1 FIGURE 25 Closer Installation CLOSER 1/4" NOTE: Be sure door opens and closes freely before installing the closer. Some models have two closers and others have one closer. "HOLD OPEN" WASHER EXTEND ROD 1/4" OUT FLANGE CLOSER ASSEMBLY PREPARATION 1. Slide hold-open washer onto closer rod as shown. Pull rod out of closer so that there is a 1/4" gap per Figure 25 (insert small screwdriver in rod hole to provide pulling grip). Position washer behind flanges and against the closer. This will give proper tension for installation. (Do not change until installation is complete. ) See Figure 25. Assemble the closers as shown in Figure 27. Attach front hole in closer to door bracket (long connecting pin). Attach closer rod to side jamb bracket (short connecting pin) with open side of jamb bracket toward storm door (see arrow on bracket). Close and latch door. FIGURE 26 #10 X 1/2" SCREW #10 X 1 1/2" SCREW SHORT PIN LONG PIN INSTALLATION: ONE CLOSER MODELS 1. To install the closer, hold closer assembly 1-1/2" down from top of door and hold jamb bracket 1/4" back from storm door. Mark jamb bracket holes and two holes in door bracket. Fasten jamb bracket to jamb with four #10x1 1/2" screws (see Figure 26). The open side of the jamb bracket should be toward the storm door (see arrow on bracket). Hold the closer and door bracket level and mark the location for the insertion of the door bracket screws. [. . . ] Call the Larson Homeowner Helpline at 1-888-483-3768. 10 202220565 CLASSIC-VIEW SERIES Brass Locksets, Deadbolts, Name Plates CLASSIC-VIEWTM TROUBLESHOOTING A SYMPTOM Door binding. POSSIBLE CAUSE Hinge to Jamb screws are too tight. Raise expander so that bottom of sweeps only touch top of threshold. Lubricate with 3-in-1 oil, cooking oil, or a silicone spray lubricant. [. . . ]