User manual LARSON EASY-VENT

[. . . ] 202220566 EASYVENT LM 10/04 EasyVentTM Storm/Screen Doors INSTALLATION INSTRUCTIONS Congratulations on your new storm door. Your satisfaction is Larson's number one priority. If you need assistance or parts, please call the Larson hotline or visit our website. READ BEFORE BEGINNING INSTALLATION TOP Z-BAR OR DRIP CAP HINGE SIDE Z-BAR PINCH CAUTION · Read installation instructions thoroughly. [. . . ] Start at one end, snap the cover on working your way towards the other end. NOTE: Be sure to insert the edge toward the door first, then snap in outer edge. · Cut the latch and hinge z-bar screw covers to length--matching the z-bar lengths respectively. NOTE: Cut covers using a scissors or a tin snips. · Attach the latch and hinge z-bar screw covers per Figure 12 as described above. TOP Z-BAR (DRIP CAP) SCREW COVER VINYL SCREW COVER HINGE Z-BAR SHOWN HINGE Z-BAR LATCH Z-BAR INSTALLED POSITION FIGURE 13 202220566 EASY VENT 5 STEP 11 Some door models have a protective tape over the door frame on both outside and the inside surface. Adjust the bottom expander so that the vinyl sweeps touch the door threshold. The slotted holes in the expander should be located on the inside of the door. Centrally locate the two #6 x 3/8" pan head screws in the slot to allow for future adjustments. Drill 3/32" diameter pilot holes for the screws, being careful not to drill all the way through to the front face of the door. NOTE: Pilot holes must be drilled or screws will break! Remove Protective Tape and Adjust Bottom Expander #6 x 3/8" PANHEAD STAINLESS #6 x 5/8" FLATHEAD SCREW STEP 12 Refer to separate instructions packaged in the hardware box. Install Latch and Strike Hardware STEP 13 This door has a retractable screen located in the masterframe head. · To ventilate make sure sash lock is unlocked, then pull down on top insert. · To close, push up on the insert. · If the screen comes out of the track, it should be pushed back in place before retracting or simply close the insert and the screen will reposition itself. · Use the sash lock to secure the top insert in place. NOTE: Slow, steady operation should be used to open and close screen. Glass Sash/ Screen Operation 6 EASY VENT 202220566 EasyVent Series Storm/Screen Door CLOSER INSTRUCTIONS NOTE: Be sure door opens and closes freely before installing the closer. STEP 1 CLOSER ASSEMBLY PREPARATION · Slide hold-open washer onto closer rod as shown. Pull rod out of closer so that there is approximately a 1/4" gap per Figure 1 (insert small screwdriver in rod hole to provide pulling grip). Position washer behind flanges and against the closer. This will give proper tension for installation. (Do not change until installation is complete. ) See Figure 1. · Attach brackets to closer as shown in Figure 2. Attach front hole in closer to door bracket (long connecting pin). [. . . ] Using needle nosed pliers, pull down on balance approximately two (2) inches and slowly allow balance to slide into insert and reposition itself. Reposition hinge closer to inside edge of door masterframe (see instructions). Raise expander so that bottom of sweeps only touch top of threshold. Readjust door bracket to allow only 1/16" or less of the unpainted portion of closer rod to show (see closer instructions). [. . . ]