User manual LARSON EZ100-200

[. . . ] Cutting starts in step 3. Page 1 Width (W) Height (H) Subtract 3-3/8" (w)- 3-3/8"= Top & Bottom Rails Subtract 11/16" (H)- 11/16"= Sill Cassette 3 Cut Top and Bottom Rails Cut the rails to your adjusted measurement from step 2. Note the difference for single and double screens. Top Rail Bottom Rail Crimp the channels at both ends of the rail to lock the brush pile in place. Note: Any crimp marks on the ends will be covered by other rails and will not be visible. Single Screens: Cut length = (W) - 1-3/4" Double Screens: Cut length = (W) - 3-3/8" Crimp SINGLE SCREENS ONLY 4 Cut Latch Rail Remove the second magnet strip and save for step 10. Note: The first magnet is secured to the latch rail. Disconnect The Second Magnet Crimp Cut the latch rail to your (H) measurement from step 2. Crimp the channel at both ends of the rail to lock the magnet in place. Cut length = (H) 5 Cut Cassette Remove shipping wrap from cassette. On the end shown, slide both the screen roll and pull bar 1/8" into the cassette. [. . . ] Screen is difficult to pull across the opening. Solution Insert back corner of cassette into the mounting clip, then rotate the cassette into the front of the mounting clip to lock in place. Secure wedges or shims under the bottom rail as necessary to hold level. Lubricate the groove with silicone spray. Verify the shorter handle is installed on the inside track. Raise or lower the inside handle as necessary. Verify the rounded profile of the cassette faces out (visible from the outside). Verify the cassette has a 90 degree cut. Verify screws in top and bottom rail are flush with the track. Check for and clean debris in bottom rail. On double screen units, verify the slide bolt strikes are installed properly and not interfering with top and bottom rails. Verify brush pile in the top or bottom tracks are not binding. Crimp the track or shorten the brush pile as necessary. Adjust the number of turns on the screen winding. You will need to remove the assembly, and unattach the spring assembly (step 6) Caution - hold onto the end cap tightly as it is under tension and will unwind. Turn the end cap a few turns to suit your needs. Clockwise to tighten tension and speed up screen or counterclockwise to loosen tension and slow down screen. If unit was cut short, use shims on the bottom as necessary. Verify the unit is plumb and level and the opening is square. Replace the cassette through Larson Manufacturing or local store. Note, you will need the model, size and color or your system. Crimp the ends of the channels on the top and/or bottom rail to lock the brush pile in place. Screen binds or will not retract into the cassette properly. Screen retracts too fast or too slow. Screen falls out of the top guide. Screen is torn. [. . . ] Double screens: Drill four 1/8" holes (1" deep) evenly spaced, on both the top and bottom rails. Drill 3/8" holes through the face of the rails using the pre-drilled 1/8" holes as a guide. This will allow the screw to be attached and be covered with the rubber plugs provided. Note: Press the "view" spacer into the rail to separate the brush pile during screw installation. 4 Screws Evenly Spaced 4 Screws Evenly Spaced Drill On Groove Line 2 Screws Evenly Spaced Drill Two 3/16" Drainage Holes SINGLE SCREENS DOUBLE SCREENS Secure with screws (see screw illustration below). #8 x 1" Phillips Pan Head DOUBLE SCREENS ONLY 15 Slide Bolt Lock Installation Slide Bolt Slide Bolt Lock Screw Extend the passive screen until the magnet is centered in the entryway opening. [. . . ]