User manual LASERLINE 921K

[. . . ] Note: always switch OFF the immobiliser before switching ON the ignition key as accidental activation of Self-Learning Procedure may occur. If accidental activation of Self-Learning Procedure does occur, wait for LED to flash at a rate of 1 flash per 2 seconds before disarming. All the wires of the immobiliser are black and are recognisable by a code printed on the end of them. When the installation is completed, all the codes on the ends of the wires are removed so that they are not identifiable and the immobiliser cannot be neutralised. [. . . ] If not interrupted, the LED will flash 10 times. Turn ON the ignition key for 1 second after the LED as displayed the flashes corresponding to each digit of your PIN CODE, read PIN CODE at the end of these instructions from left to right. For a better understanding, see the example. If the inserted PIN CODE is correct, the immobiliser will disarm itself and automatically enter the "SELFLEARNING PROCEDURE", signaling this condition by LED ON for 10". Follow SELF-LEARNING PROCEDURE from step 6. If the inserted PIN CODE is wrong, the immobiliser will remain ON. Note After the above operations, any lost or stolen CODED KEYS become useless. Code memorisation can only occur when the LED located in the receptacle is constantly on. No more than 10 seconds must elapse between memorising each CODED KEY. When 4 CODED KEY have been memorised, the immobiliser will automatically exit from the self-learning procedure or 10 seconds after the last CODED KEY was memorised. If a new CODED KEY has been memorised, it is necessary to memorise the original CODED KEYS if their continued use is desired. If only one CODED KEY is available no SELF-LEARNING PROCEDURE will take place and the procedure will enter EMERGENCY CODE (PIN CODE) DISPLAY PROCEDURE. To memorise only one CODED KEY follow the "USING THE EMERGENCY CODE (PIN CODE) TO DISARM THE IMMOBILISER" procedure and memorise single CODE KEY. LIFETIME WARRANTY Product warranty covers units to be free from defects in manufacture for the lifetime ownership of the original vehicle, in accordance with the terms and conditions of this warranty document. Any product, which is deemed to be defective, will be replaced or repaired. Accessories including remote controls, touch keys and additional modules are guaranteed for a period of 12 months from date of installation. Terms and Conditions 1. Product must be installed by an authorised qualified installer. If product is transferred by an authorised installer onto another vehicle then in this case the warranty reverts back to 2 years from the date of the original installation. Warranty is not transferable by the original customer to other owners of the product accessory. The customer must complete and return the warranty registration document within 21 days from date of purchase in order for the warranty to be valid. The warranty covers product only and not the quality of the installation. The warranty for installation is provided by the installer. We cannot be held responsible for costs arising due to incorrect installation. All warranty claims must be directed through the original installer, accompanied by the original invoice, detailing date of installation and annual service record. [. . . ] Turn the ignition OFF and after a pause, the LED will flash for the next digit of the PIN CODE; Third digits 0 - For the 0 digit, the flashes to be completed on the LED are 10. Continue until all the digits have been displayed and inputted correctly. USER MANUAL IMMOBILISER MODEL 921K YOUR PIN CODED IS: IMMOBILISER WITH ELECTRONIC KEY FOR ALL CARS WITH 12V NEGATIVE EARTH ELECTRICAL SYSTEMS NOTE Manufacturer declines any responsibility for damage of the immobiliser and the vehicle electrical system due to WRONG INSTALLATION OR TAMPERING. LASERLINE SpA RESERVES THE RIGHT TO EFFECT CHANGES OF THE PRODUCT WITHOUT FURTHER NOTICE. TEST APPROVAL NUMBERS MIRRC Reference Number: TE2 - 1188/1100 Category 2 WE ADVISE YOU TO CHOOSE AN ACCREDITATED INSTALLER. [. . . ]