User manual LAUNCH X-431

[. . . ] LAUNCH X-431 User's Manual Trademark Information LAUNCH is a registered trademark of LAUNCH TECH. (short for LAUNCH ) in China and other countries. All other LAUNCH trademarks, service marks, domain names, logos, and company names referred to in this manual are either trademarks, registered trademarks, service marks, domain names, logos, company names of or are otherwise the property of LAUNCH or its affiliates. In countries where any of the LAUNCH trademarks, service marks, domain names, logos and company names are not registered, LAUNCH claims other rights associated with unregistered trademarks, service marks, domain names, logos, and company names. [. . . ] Rule: The one who chooses white chessman can play 35 Memo The basic functions of Memo include: add new memo, view memo, delete memo, browse by types, etc. 1) In the pop-up `PIM' list, select `Memo' to open the Memo interface. (See Figure 4-19) 2) After you click the [] button on top right corner, the type list will pop up. Then you can select the type of the memo. 3) You can also select the Edit Group in the type list to open the Edit Group interface. 4) The memo list of corresponding type will LAUNCH X-431 User's Manual 5) 6) be displayed in the list box on the midst of the Memo interface. Click one memo in the memo list to open the Memo Edit interface. Click [New] button to open the New Memo interface. 3) memo in the opened Memo Edit interface. After editing, click [OK] button to save the edited contents and close the Memo Edit interface. Figure 4-20 Figure 4-19 Add New Memo 1) In the Memo interface, click [New] button to open the New Memo interface. 2) Activate Soft Keyboard, and fill the subject and contents. 3) Click the button on top right corner, then select the type in the pop-up list 4) Click [OK] button to save and close the New Memo interface. 5) Then you can see the new memo in the list box of the Memo interface. View Memo 1) In the list box of the Memo interface, click the memo that you want to view. 2) Then you can view the contents of the memo in the opened Memo Edit interface. 3) Click [OK] button to close the Memo Edit interface. Edit Memo 1) In the list box of the Memo interface, click the memo that you want to edit. 2) Then you can edit the contents of the 36 Delete Memo 1) In the list box of the Memo interface, click the memo that you want to delete. 2) Then you can delete the memo in the opened Memo Edit interface. 3) Click [Delete] button to delete the memo and close the Memo Edit interface. Edit Type 1) Click the [] button on the top right of the interface so that the type list pops up. 2) In the type list, select the Edit Group to open the Edit Group interface. 3) In the Edit Group interface, activate Soft Keyboard. [. . . ] If the fault message like "Power cut owing to undervoltage (constant value)" is displayed for auxiliary heating device (code is 00001), please perform the following steps: 1) Change the code of auxiliary heating device to 00002 and confirm the control unit code; 2) Read out the inputted value (constant value) of uncervoltage power cut by means of the 77 LAUNCH X-431 User's Manual function [Adaptation] and then perform adaptation; 3) Alter the constant value by means of the function [Adaptation] (Specified value is below 10. 5V); 4) Change the code of auxiliary heating device to 00001. Confirm the control unit code. 2) Control unit-J162 (software version No. is D49 or over) Code Signification With recirculation pump-V55 00011 Power cut owing to undervoltage for adaptation when the basic setting is reached. With recirculation pump-V55 00012 Power cut owing to uncervoltage when the inputted voltage for adaptation is reached. [. . . ]